Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EnglisH
6
Note: Make sure the projection on the lid locks into the slot of the bowl
handle.
5
When you use the insert holder with one of the inserts, add the
ingredients through the feeding tube and push them down with
the pusher.
6
Select the speed setting that corresponds with the colour of the
accessory you choose. See the appropriate section below.
7
When you have finished processing, turn the speed selector to
0 (Fig. 4).
Feeding tube and pusher
-
Use the feeding tube to add liquid and/or solid ingredients. (Fig. 5)
-
Use the pusher to push solid ingredients down the feeding
tube. (Fig. 6)
Tip: You can also use the pusher to close the feeding tube. This prevents
ingredients from escaping through the feeding tube.
Blade unit
You can use the blade unit to chop, mix, blend or puree ingredients.
1
Remove the protective cover from the blade (Fig. 7).
The cutting edges are very sharp. Do not touch them.
2
Put the tool holder in the bowl. (Fig. 8)
3
Put the blade unit on the tool holder in the bowl (Fig. 9).
4
Put the ingredients in the bowl. Pre-cut large pieces of food into
pieces of approx. 3 x 3 x 3cm (Fig. 10).
Note: Always put the tool holder with the blade unit in the bowl before you
add the ingredients.
5
Put the lid on the bowl (1). Turn the lid clockwise (2) to fix it
('click') (Fig. 11).
Note: Make sure the projection on the lid locks into the slot of the bowl
handle.
4222.005.0179.1.indd 6
6
Put the pusher in the feeding tube.
7
Select the speed that corresponds with the colour of the
accessory (Fig. 12).
8
When you have finished processing, turn the speed selector to 0
and unplug the appliance (Fig. 4).
Tips
-
When you chop onions, turn the speed selector to P (pulse
position) a few times to prevent the onions from becoming too finely
chopped (Fig. 13).
-
Do not let the appliance run too long when you chop (hard) cheese
or chocolate. Otherwise these ingredients become too hot, start to
melt and turn lumpy.
-
Do not use the blade unit to chop very hard ingredients like coffee
beans, turmeric, nutmeg and ice cubes, as this may cause the blade to
get blunt.
-
If food sticks to the blade or to the wall of the bowl, switch off the
appliance and unplug it. Then use a spatula to remove the food from
the blade or from the wall of the bowl.
Kneading accessory
You can use the kneading accessory to knead yeast dough for bread and
pizzas.
1
Put the tool holder in the bowl (Fig. 8).
2
Put the kneading accessory on the tool holder. (Fig. 14)
Note: Always put the tool holder with the kneading accessory in the bowl
before you add the ingredients.
3
Put the ingredients in the bowl (Fig. 15).
4
Put the lid on the bowl (1). Turn the lid clockwise (2) to fix it
('click') (Fig. 16).
Note: Make sure the projection on the lid locks into the slot of the bowl
handle.
10-11-10 14:03
Publicidad
Tabla de contenido
Solución de problemas
