SPECIFICATIONS
These units are sold in multiple regions with different
requirements for measuring capacity. Below are a few
of the valid forms of measure posted on this product:
Dry Linen Capacity: A weight measure that reflects a
maximum load size that can be loaded into the washer.
IEC Capacity: The capacity measure that represents the
maximum capacity of dry linens and textiles which the
manufacturer declares can be treated in a specific cycle.
WHAT'S NEW UNDER THE LID?
Your new washer will operate differently than your past agitator-style washer.
Lid Locked
To allow for higher spin speeds, the lid will lock and the
Lid Locked light will turn on. When this light is lit, the lid is
locked and cannot be opened. When this light is blinking,
the washer is paused. When this light is off, the lid can be
opened. After a cycle is started, the lid locks, unlocks, and
locks again. If you need to open the lid to add a garment
after this point, you must press START/PAUSE/UNLOCK
and wait for the lid to unlock. The lid will only unlock after
washer movement has stopped. Depending on when in
the cycle you try to pause, it may take several seconds to
several minutes for the lid to unlock.
Sensing
This washer will perform a series of spins to check
for load balance. When a load is started, it may take 2–3
minutes before water begins to enter the basket. During
this time, a series of clicks and a whirring noise signal
that sensing technology is determining if there is an off-
balance load.
IMPORTANT:
• Washer will not operate if the lid is open.
• Washer will not begin to fill with water until the lid is closed, locked, and the sensing process is complete.
This delay in fill could take 2–3 minutes.
Dry Linen Capacity
15 kg (33 lb)
IEC Capacity
7,5 kg (16,5 lb)
Sound Level:
Lpa < 70 dB(A) (Kpa: +/- 2,5 dB(A))
Sounds
At different stages of the wash cycle, you may hear
sounds and pauses that are different from those of your
previous washer. For example, you may hear a clicking
and hum at the beginning of the cycle as the lid lock
goes through a self-test. There will be different kinds of
humming and whirring sounds as the agitator tests for
load balance or moves the load. And, sometimes, you may
hear nothing at all as the washer allows time for clothes to
soak.
Spray Rinse
Select cycles default to a spray rinse. During these cycles,
you will hear water enter the washer as the tub spins,
allowing the rinse water to penetrate clothes. Check the
"Cycle Guide" for details.
3