Axis Communications P5512-E PTZ Guia De Instalacion página 9

AXIS P5512-E Installation Guide
Install the network camera
!
IMPORTANT!
The supplied RJ45 connector or a compatible, IP66 rated RJ45 connector must be used in order to
comply with the IP66-rated design of the camera.
1. Install the selected bracket (not
included) according to the
instructions supplied with the
bracket. If drilling is required,
make sure to use drill bits,
screws, and plugs that are
appropriate for the material.
See www.axis.com for informa-
tion on available mounting
accessories.
2. Route the network cable and
attach the supplied RJ45
connector. Refer to the
instructions provided with the
connector for information on
wiring and assembly.
3. Hook the camera to the safety wire on the bracket.
4. Connect the network cable and RJ45 connector to the network connector on the camera.
5. Check that the indicator LEDs on the midspan indicate the correct conditions. See the table on
page 10 for further details.
6. Slide the unit holders on the camera into the slots on the bracket and rotate the camera unit.
7. Secure the network camera to the mounting bracket by fastening the 3 screws (Torx T30).
Safety
wire
Wall bracket (mounting example, bracket not included)
Page 9
Torx T30
Screws
Slots for
unit holders