Installation Instructions - eisl ORS9090AL Instrucciones De Montaje

Installation instructions

GB
Dear customer,
You have purchased a high-quality and long-lasting product
from our line of goods. Please read these instructions care-
fully before assembling and observe the notes.
Therefore, keep the instructions in a safe place and pass
them on to possible subsequent owners.
Proper use
This product is suitable for use with instantaneous water
heaters. It is not suitable for low pressure water heaters
such as wood or coal burning bath geysers, oil or gas bath
geysers, open electrically heated water tanks. Any use other
than that described here or modification to the product
is not permitted and may lead to damage to persons or
property. There is also the risk of injury and loss of life. The
product is intended for personal use only and not for medi-
cal or commercial use.
Safety notes
• ATTENTION!
Risk of breakage if weight is put on glass parts!
• Please arrange for installation to be carried out by two
proficient persons.
• CAUTION DAMAGE BY WATER!
Prior to installation please turn the general water supply
off.
• Ensure that all gaskets have the correct fit.
• These taps are not suitable for use on low pressure and
small electrical storage heaters.
• We recommend the installation of a filter into the appli-
ance or at least the use of angle valves with filter, in order
to avoid the inflow of foreign matter, which could damage
the cartridge.
• This tap is only intended for use in private households!
Only suitable for use in rooms with a temperature over 0 °C,
when there is danger of frost, sut off the water supply and
empty the tap.
• Take care when adjusting the warm water. Danger of
scalding!
• Incorrectly installed fittings can cause water damages!
• Make sure that no caustic or corrosive agents, such as
cleaning agents or household detergents come into
contact with the surfaces of the shower cubicle. This may
cause damage to the surfaces or water damage.
• Despite careful production, sharp edges can occur. Please
exercise caution!
• DANGER OF LOSS OF LIFE AND ACCIDENT TO INFANTS
AND CHILDREN! Never leave children unsupervised with
the packaging materials. Danger of suffocation.
• CAUTION! DANGER OF INJURY!
Please ensure that no parts are damaged and that all parts
are correctly assembled. Incorrect assembly or fitting may
lead to injury.
Damaged parts can adversely affect safety and proper
function.
• CAUTION DANGER OF WATER DAMAGE! Before installa-
tion please ensure that there are no water pipes where you
are intending to drill.
• Examine the wall before installation and choose suitable
installation fixings.
We have supplied fixings suitable for an ordinary solid
masonry wall.
• Please note that seals are wear parts and therefore will
require to be replaced from time to time.
• Warning - risk of electrocution! Make sure that there
are no electrical power lines where you are drilling before
starting to drill holes.
Disposal
Your washbasin tap is delivered in a solid packaging, in or-
der to protect it against transport damages. The packaging
consists of recyclable materials. Dispose it in an environ-
mentally suitable manner.
Do not throw the product into the normal domestic waste at
the end of its service life, but ask your municipal administra-
tion about the possibility of an environmentally friendly
disposal.
Installation Instructions
• Check all connections carefully after first-time use to make
sure that they are tight.
• We do not assume any warranty for incorrect installation -
in particular for subsequent damages!
Instructions for care
Sanitary taps require special care. Therefore, please observe
the following instructions:
• Chrome-plated, painted or aluminium surfaces are
sensitive to limescale removers, acidic detergents and all
types of scouring agents.
• Never clean coloured surfaces with abrasive, corrosive, or
alcoholic agents.
• Only clean your taps with clear water and a soft cloth or a
shammy.
Maintenance
• Please check all joints and connections for leaks or visible
damages at regular intervals.
• In the event of leaks or visible damage to the shower
cubicle, the connection hoses or the drain, these should be
checked or replaced immediately by a specialist.
Decommissioning
• Cut off the water supply before dismantling the product.
• Pay attention to escaping residual water.
• Disassemble the product in the reverse order of the as-
sembly instructions.
 The illustrations are to be considered as figurative
representations, deviations of the product are possible.
Subject to technical modifications.
WARRANTY CARD
The Eisl Sanitär GmbH, based in Wallenhorst, shall take on a
manufacturer's warranty for the product you have procured
in accordance with the warranty conditions stated below.
Your legal warranty claims from the purchase contract with
the seller and your legal rights shall not be limited by this
warranty.
7