ibico pouchMaster PQ Instrucciones De Servicio página 4

pouchMaster PQ
Operation, hot lamination
Connect power cord to appropriate power source.
Push power button to "ON" position. The green power indicator will
1
illuminate.
2 Using the included lamination guide, select appropriate temperature setting
for the pouch gauge thickness and material you are laminating.
Temperature Setting Guidelines*
When laminating thin paper with light ink coverage, set the temperature
dial at the low end of the range. Thick paper and heavy ink coverage
require higher settings within the range. Temperature setting will vary due
to the finish, chemistry and heat absorption properties of the material
being laminated. If pouch is cloudy the first pass through the machine,
adjust temperature higher and run through again. If waviness occurs,
reduce the temperature. Always allow sufficient time for laminator to
adjust to changes in temperature setting.
Anti-jam feature
How to use the Release Lever (fig. 2)
Turn off the laminator immediately
1
Press the release lever down to release the motor from the rollers
2
Pull your document back out of the laminator
3
Clean the rollers by running the cleaning sheet supplied with the laminator
4
through the machine 2 or 3 times in hot operation mode. If you do not
have this sheet just use or a similar cardboard sheet that fits the width of
the laminator
Specifications
Electrical
Machine Dimensions
Machine Weight
Maximum Pouch Width
Minimum/Maximum Pouch Thickness
Warm-Up Time
EDNord - Istedgade 37A - 9000 Aalborg - Telefon 96333500
Ibico pouchMaster PQ ®
230V/50Hz/3.1A/700W
500 x 220 x 120mm
4.1kg
324mm
2x80 mic. (TOTAL 160)
2x250 mic. (TOTAL 500)
3-5 min./2x80 mic. (TOTAL 160)
®
3 The ready light will illuminate when the laminator has reached operating
temperature.
4 Position the item to be laminated into an Ibico laminating pouch,
so that the document is aligned to the folded edge and right and left
borders are equal.
5 Insert the pouch and its contents straight into the machine, leading with
the sealed edge (fig. 1).
6 The laminated document will automatically exit the rear of the laminator.
After the pouch has stopped moving, place it on a flat surface to cool
before handling.
7 When you are finished laminating, push the power switch to "OFF".
Do not laminate an empty pouch.