Use And Operation; Replacement Parts - KUULAIRE PACKA44 Manual De Usuario

TROUBLESHOOTING
Symptom Possible Cause
WARRANTY
No discharge of air Cord is not plugged in
Power is not on
The unit will not Damaged PCB
turn off Remote Control Batteries
CLEANING AND MAINTENANCE
Calcium Build-up in Blower
Water Flow Control truned too low
Unit is making noise Calcium Build-up in Blower
Water Flow Control truned too low
TECHNICAL SPECIFICATIONS
Not cooling Low/No Water
Water Level Sensor is stuck
Odor Emission Brand new unit
REMOTE CONTROL
Old Unit with algae
Water droplets coming Calcium saturated water
out of air outlet Clogged media

USE AND OPERATION

▲
!

REPLACEMENT PARTS

To obtain a current list of Replacement Parts, visit us
PARTES DE REPUESTO
online at www.port-a-coolparts.com.
Possible Solution
Make sure cord is plugged in and try to turn the unit on pressing buttons
on control panel and remote control. Check the circuit breaker or check
GFCI reset button.
Try to use remote control to see if unit responds
Check batteries.
Deep clean unit — remove calcium debris.
Change water flow control setting
Deep clean unit — remove calcium debris.
Change water flow control setting
Check water level
Drain/refill with fresh water and/or clean water tank
Brand new media will initially emit an odor which will dissipate within
a week of initial use.
If the unit is not new, there may be an algae issue. Replace the rigid
media pads and clean the pads regularly.
Drain water, deep clean and clean the media.
Media may need to be replaced.
Port-A-Cool, LLC • 709 Southview Circle • Center, TX 75935
www.kuulaire.com • 1-888-999-6511
5