Tabla de contenido
Publicidad
Serie Solution - Manual de Usuario y Mantenimiento
A d v ice To Australian U sers
The Austel permit that has been issued for this product is subject to the following conditions:
•
N e w Z e a land Tele p e rm it N o tes
•
•
•
•
•
•
•
•
The Solution Ultima Series control panel may only be powered by an EDM TF008
plug pack (Approval Number Q92128).
The grant of a telepermit for a device in no way indicates Telecom acceptance of
responsibility for the correct operation of that device under all operating conditions.
This equipment shall not be used in any manner that could constitute a nuisance to
other telecom customers.
Immediately disconnect this equipment should it become physically damaged and
arrange for its disposal or repair.
The transmit level from this device is set at a fixed level and because of this, there
may be circumstances where the performance is less than optimal. Before reporting
such occurrences as faults, please check the line with a standard telepermitted
telephone and do not report a fault if the telephone performance is satisfactory.
This device is equipped with pulse dialling while the Telecom standard is DTMF tone
dialling. There is no guarantee that Telecom lines will always continue to support
pulse dialling.
Use of dialling, when this equipment is connected to the same line as other equipment,
may give rise to bell tinkle or noise and also cause a false answer condition. Should
such problems occur, the user should NOT contact the Telecom Faults Service.
This equipment is set up to carry out test calls at pre-determined times. Such test calls
with interrupt any other calls that may be set up on the line at the same time. The
timing set for such test calls should be discussed with the installer.
The timing set for test calls from this equipment may be subject to drift. If this proves
to be inconvenient a nd your calls are interrupted, then the problem of timing should be
discussed with the equipment installer. The matter should NOT be reported as a fault
to Telecom Faults Service.
This equipment shall not be set up to make automatic calls to the Telecom 111
Emergency Service.
This equipment should not be used under any circumstances that may constitute a
nuisance to other Telecom customers.
In the event of any problem with this device, the systems battery, AC mains supply
and telephone line should be disconnected.
supplier of the device to make the necessary repairs.
Should the matter be reported to Telecom as a wiring fault and the fault be proven to
be due to this product, a call-out charge will be incurred.
Detection Systems Argentina
The user is to then arrange with the
37
Publicidad
Tabla de contenido
