GE current Evolve LED Post Top Town & Country - EPTT Guia De Instalacion página 2

1
UNPACKING/HANDLING
• This luminaire has been packed to ensure no damage
during transit. Inspect to confirm.
• Do not impact or stack luminaire after unpacking.
2
MOUNTING
WARNING
Risk of injury or damage. Unit will fall if not installed
properly. Follow installation instructions.
• This luminaire is provided with means for mounting on
2-3/8 inch (60mm) to 3 inch (76mm) outside diameter
pole tops.
• Feed the power supply leads through the slipfitter
wire access hole as the fixture is installed on the pole.
• Orient canopy screw or latch toward street and level
luminaire by adjusting the 3 mounting screws, and
tighten.
• CAUTION: Tighten mounting screws to 15-20 ft-lbs.
(20-27 N-m).
• Remove shipping ties from wire way in the rear upright.
DO NOT torque bolts greater than 20 ft-lbs. Damage
may occur.
WARNING
Cupola
Shipping Ties
Mounting Screws
3
WIRING
• NOTE: Make all electrical connections in accordance
with the National Electrical Code and any applicable
local code requirements including grounding.
• NOTE: Verify that supply voltage is correct by comparing
it to nameplate.
• Remove cover at base of unit.
• Connect all 3 power leads to the terminal block as
noted in table 1. Torque to 35 in-lbs
• Replace cover.
TABLE 1. Terminal Board Connections
Terminal Board Position
L1
G
N/L2
Cover
Terminal Block
Risk of injury. LED light source achieves full intensity
immediately upon being powered on. Do not look directly
at LED light source while energized during install.
Supply Lead
High Line
Ground
Low Line/Neutral
WARNING