TAD DA1000 Manual De Instrucciones página 19

Symptom
Display is not visible. The display viewing angle is within 45° to right/
left from the front of the unit.
The unit is set to display off.
The remote control  The remote control's batteries are expended.
doesn't work.  The remote control is being used too far
 Angle is bad.
 Line of sight to the main unit is blocked.
 Strong light from a fluorescent lamp or
Static electricity or other external influences may cause malfunctioning of this unit. In this case, unplug the power cord and
then plug back in. This will usually reset the unit for proper operation. If this does not correct the problem, please consult your
dealer.
This unit is designed as a consumer audio product (audio/video component). It is not designed for long continuous
use as a commercial BGM source, nor for use in automobiles, ships, or outdoors.
Possible cause
away from the main unit.
other light source is directly striking the
signal receiver.
Remedy
View the display from immediately in front of the
unit.
Press the DISP button to disable the display off
mode.
 Replace the batteries with new ones.
 Use the remote control from within a distance
of 7 meters (23 ft.), and within an 30° arc to
right/left of the unit's front panel.
 Remove obstacles between the main unit
and remote control, or change to a different
location when operating the remote control.
 Readjust the position of lamps or other light
sources so that strong light does not strike the
signal receiver.
19