Nowsonic ROADTRIP 51 Instrucciones De Uso página 7

ROADTRIP 51
GB
User manual
Microphone / instrument section (mono)
The microphone / instrument section of Roadtrip 51 serves for connec-
ting a wired microphone, an instrument, or a monophonic line device.
This section has the MIC 2 INPUT Combo socket (1) that can be connec-
ted with either a balanced XLR or an unbalanced 1/4" TS cable.
1
NOTE: The XLR connectors of the Combo socket do not provide phan-
tom power. Therefore you can connect only dynamic or self powered
condenser microphones.
With the MIC 2 VOL (2) control you can adjust the level of the connected
source in the Master section. With the TONE control (3) you can easily alter
the sound of the connected source: Turn the knob counterclockwise to
attenuate the high frequencies and to emphasize the lows. Turn the knob
clockwise to emphasize the high frequencies and to attenuate the lows.
Line-In-section
This section serves for connecting an external stereo device with line
level (e.g. a CD player or even a keyboard).
Connect the external device to the LINE IN sockets (5) using RCA cables.
Next adjust the volume of the connected source in the Master section
using the LINE VOL (4) control.
2 3
4
5
Master-section
In the Master section you turn Roadtrip 51 on and off and set the level
of the stereo buss that is sent to the internal class D amplifier and the 8"
full range speaker.
6 7
The LINE OUT (6) RCA outputs allow for tapping the signal in the stereo
buss before the MASTER VOL (8) and the class D amplifier. Via these out-
puts you can feed the stereo signal of Roadtrip 51 to a subsequent mixer,
a recording device (e.g. a MD recorder) or to another Roadtrip 51.
With the TALKOVER control (7) you can set an attenuation (0 to -20dB) for
signals from the Bluetooth and line sections: the signals are attenuated
by this amount when the UHF receiver receives a signal from the wirel-
ess microphone or a microphone / instrument signal is present in the
microphone / line section. Thanks to this auto mix function microphone
announcements are transmitted with high intelligibility over the back-
ground music.
The MASTER VOL knob (8) controls the level of the stereo buss that is sent
to the internal amplifier and the 8" full range speaker. Turning the knob
clockwise increases the gain.
Finally, use the POWER switch (9) to turn Roadtrip 51 on or off. In order to
avoid any damages to the internal speaker, first turn down the MASTER
VOL control (8).
NOTE: The internal battery of Roadtrip 51 is only charged when the PO-
WER switch is set to ON. The battery will not be charged when the power
cord is connected, but Roadtrip is not turned on.
8
www.nowsonic.com
8 9