General Operation; Installing/Removing Battery Pack; Lock-Off Button; Switch Trigger - Dexter 20VAG3-125BL.1 Manual De Instrucciones

FR FR
ES ES 5. OPERATION
PT PT
To install:
IT IT
Insert the battery pack. Push battery pack into the bottom of the handle and that battery pack is
secured in the product before beginning operation.
EL EL
To remove:
Depress the battery pack unlock button and by pulling the battery pack out. For complete charging
PL PL
instructions, see the operator's manuals for your battery pack and charger.
RU RU
The lock-off button is located on the handle above the switch trigger. You must depress the lock-off
KZ UA
button in order to pull the switch trigger. This button resets each time when the switch trigger is
released.
KZ UA
To turn the grinder ON, depress and hold lock-off button, then depress the switch trigger. To turn it
RO RO
OFF, release the switch trigger.
BR
BR
NOTE:The switch trigger in a original position(position 0) before pressing the rotating button.Press
the rotating button,rotate the soft grip handle anticlockwise to make the switch trigger be in a
horizontal position (position1).
Press the rotating button again,rotate the switch trigger in a upturned position (position2).
After adjusting the switch trigger position,reinstall the auxiliary handle is necessary.
The auxiliary handle is able to be installed on any side of the gear case. Position the auxiliary handle
in the location which offers best control and guard protection.
To install, thread auxiliary handle into auxiliary handle socket and tighten securely.
1. If you have just installed an accessory or are beginning a period of work, test the disc by letting
it spin for one minute before applying it to the workpiece. WARNING! Never use a accessory
that has been dropped. Out-of-balance or damaged accessories can mar workpiece, damage
the tool, and cause stress that may cause accessory failure.
2. Use a clamp, vise or other practical means to hold your work, freeing both hands to control the
tool.
3. WARNING! Hold tool securely with both hands. NOTE: If the battery is inserted when the tool
is ON, the tool will not run. Turn the tool OFF, then back ON to begin work.
292

INSTALLING/REMOVING BATTERY PACK

LOCK-OFF BUTTON

SWITCH TRIGGER

ADJUSTING THE ROTATIONAL OPERATION POSITION

GENERAL OPERATION