ION Sound Stone Guia De Inicio Rapido página 5

Operation
Bluetooth Connecting with Sound Stone
Connecting to one Sound Stone:
1. Power on Sound Stone by holding down the Power button. You will hear "Power On" for
confirmation. *
2. Press the Bluetooth Connect button briefly to enter Connecting Mode - the Bluetooth
LED will blink fast, and you will hear "Pairing" to indicate this. *
3. Navigate to your device's Bluetooth setup screen, find Sound Stone, and connect.
Note: If you experience trouble in connecting, select "Forget this Device" on your
Bluetooth device and try to connect again. If your Bluetooth device is not able to connect
to Sound Stone, hold the Bluetooth Connect button on the speaker to break previous
Bluetooth connections and reset the Bluetooth module. The Bluetooth LED will light up
solid when it is connected and you will hear "Pairing successful, connected" for
confirmation. *
4. To disconnect, hold the Bluetooth Connect button on Sound Stone. You will hear
"Disconnected" for confirmation. *
Linking two Sound Stone units:
Note: Ensure that the speakers are not already Bluetooth-connected in Single mode
(described above). If either of them is connected, hold the Bluetooth Connect button to
disconnect and then follow the steps below.
1. Power on each Sound Stone by holding down their Power buttons. You will hear "Power
On" for confirmation.
2. Press the Link button on each Sound Stone. The speakers will search for each other
while playing an intermittent tone. Once the stereo pair is successfully linked, you will
hear "Pairing successful, connected" followed by "Left channel" and "Right channel" on
the respective speakers. * This process may take up to 2 minutes the first time two
speakers are linked. Speakers that were previously linked will relink automatically in a few
seconds if powered on in range of one another.
Note: Sound Stones should be within 30' (9.1 m) of each other to link properly.
3. On the Left speaker, the Bluetooth LED will blink. Press the Bluetooth Connect button
briefly to enter Bluetooth Pairing mode.
Note: The Left speaker will be the "master" speaker, and the unit from which the
Bluetooth range will be determined.
4. Navigate to your device's Bluetooth setup screen, find Sound Stone, and connect. You
will hear "Connected" for confirmation. *
Note: If you experience trouble in connecting, select "Forget this Device" for Sound
Stone on your Bluetooth device and try to connect again.
5. To disconnect linking, hold the Link button on the "master" Sound Stone for 2 seconds.
You will hear "Disconnected" for confirmation. *
Note: When two speakers are linked, hold the power button on the "master" speaker to
turn both speakers off. If you want to only turn off the "slave" speaker, press and hold the
power button on that speaker. The speakers will relink automatically the next time they
are both powered on.
* Tip: If you would like to disable (or enable) the voice prompts, simultaneously press the
Bluetooth Connect and Link buttons briefly.
FCC Statement
Warning: This product shall be installed and operated with a minimum distance of 20 cm between the radiator and user body.
5