Digital Compass - Bushnell Digital Navigation 70-0002 Manual De Instrucciones

Temperature Alarm
Sets the alarm to sound when the temperature measurement reaches
the programmed level. In the Alarm Mode, the Temperature alarm
uses the same measurement units (ºC or F) that were last set in the
Temperature Mode. To change this you must first change the
temperature units in the Temperature Mode. Using the UP or
DOWN buttons once changes the temperature in tenths of a degree.
Holding either button down changes the temperature in increments
of 1 degree.
Beep Function
In the Alarm mode, a Beep function is also available. When
activated, the beep function causes a beep sound to be made
whenever a button is depressed, even when the Alarm function is
turned off. To activate the function go to the Beep function in the
Alarm Mode, press the COMP button and 'ON' is displayed. Press
again and 'OFF' is displayed.
Stopwatch Mode
Press the MODE button until Stop Watch Mode is displayed. To
operate, press the UP button to start and press again to stop.
Pressing the DOWN button will reset the Stop Watch.
For split timing function, press the DOWN button while the Stop
Watch is operating in order to stop the display and press again to
continue. You can also press the DOWN button while the Stop
Watch is operating to stop the display and then press the UP button
to stop the Stop Watch and display the final reading. Press the
DOWN button again to reset the Stop Watch.
Stop Watch Mode / Split Timing Function
Split timing function is displayed as 'SPL' when activated and the
display returns to normal when DOWN button is pressed.
6
C T A
OUNTDOWN IMER LARM
Countdown / Reverse-Timer Mode
Press the MODE button until Countdown Timer Mode is
displayed, represented by 'RT' (reverse timer). To operate press the
UP button to start and press again to stop, then press the DOWN
button to reset the Countdown Timer.
To set the Countdown Timer press and hold down the ADJ button for
3 seconds, which will cause the seconds setting to blink. Adjust with
the UP or DOWN button, and then press the MODE button to
adjust next setting. Press the ADJ button to save settings and exit. Press
the COMP for 'AUTO' to allow Countdown Timer to repeat function
automatically, and press COMP again to turn off 'AUTO' function.
Press any button when alarm sounds to stop the Countdown Timer.
If nothing is pressed the Countdown Timer will stop beeping after
10 seconds, but it will continue if the 'AUTO' function is set on. To
stop the Countdown Timer if the 'Auto' function is on, you must go
to the Countdown Timer Mode and press COMP to turn off the
'Auto' function and then press UP button to stop it.
D C
IGITAL OMPASS
Compass Mode
Press the MODE button until Time Mode is displayed, and then
press the COMP button. If already in Time Mode, simply press the
COMP button and Compass Mode is displayed. Hold the compass
level using the bubble level to get a reading. If the Cardinal Points
blink then the compass probably needs to be calibrated. (See trouble
shooting tips.)
Compass Calibration
In Compass Mode, hold down ADJ button for 3 seconds.
Calibration Mode is displayed. Put the compass on a level, non-
magnetic surface and press the COMP button. The word CAL will
start blinking. Then, rotate the compass 2 full circles slowly WHILE
HOLDING THE COMPASS LEVEL. When done, press COMP
again. When completed, the display shows 'DONE' and it will then
go automatically into Declination Setting Mode. If Calibration is
7