Belkin TuneSync Manual Del Usuario página 11

Installation
PC Users
IMPORTANT NOTE: Please do not connect any USB devices to
the hub until instructed to do so in step 4 of this installation
procedure.
1. Plug the AC adapter into a wall outlet or surge protector. Plug the DC
2. Plug the flat end (USB A connector) of the provided USB device cable
Important Note: The hub must be connected to a USB 2.0-compliant host in
3. Windows will now detect your hub and install the required driver
Important Note: High-speed hub drivers are included with most USB 2.0 PCI
4. Plug the USB A connector of the USB device, or an additional hub,
Important Note: When moving a device from one port on the hub to another, it
F5U255ea.indb 5
connector into the DC power jack found on the rear of the hub.
into the downstream port of your computer or downstream port
of another hub. Then plug the square end (USB B connector) of the
device cable into the upstream port on the rear of the hub.
order to function in Hi-Speed USB 2.0 mode (480Mbps data rate). If the hub
is connected to a USB 1.1-compliant host, it will operate only in low-speed or
full-speed mode (1.5Mbps/12Mbps).
support. (The Windows "Install New Hardware Wizard" may
prompt you to provide your Windows Installation CD to complete
the driver installation process.)
upgrade cards, and are preinstalled along with the PCI card drivers. If you
purchased an upgrade card prior to the release of high-speed hub support,
please check with your PCI card vendor for an updated USB 2.0 driver.
into any of the downstream ports of the hub.
may be necessary to reinstall the USB drivers for that device.
Installation
EN
5
11/8/2005 10:06:41 AM