Atlantic Triton Serie Manual De Operación página 4

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Use PVC cleaner/primer to clean the outlet socket fitting and the end of the outlet
pipe. Apply PVC glue and insert the outlet pipe into the outlet fitting of the check
valve. Hold the outlet pipe firmly in place until the glue sets.
Connection to Kink-free tubing:
An insert step fitting for connection to 1", 1 ¼" or 1 ½" kink-free tubing is supplied
with the Triton Check Valve. Begin by installing the 2" outlet socket fitting per the
instructions above. Use PVC cleaner/primer to clean the outlet socket fitting and
the insert step fitting. Apply PVC glue and insert the step fitting into the outlet
fitting on the check valve. Hold the fitting firmly in place until the glue sets. If using
1¼" or 1½" tubing, the insert fitting will need to be trimmed to provide the proper
outlet diameter for maximum water flow. Use a hacksaw or PVC saw to cut off
smaller, unneeded inset steps at the cut lines indicated below.
CUT LINE
1"
Complete installation by tightening the union nuts on the Triton Check Valve.
HAND TIGHTEN ONLY. DO NOT USE CHANNEL LOCKS TO TIGHTEN THE
UNION NUTS.
Installation of Triton Check Valve if Using Any Equipment
Combination Not Listed Above
If you are using an equipment combination not
listed above, you will need to use the 1" 'cut-to-fit'
reference marks on the back side of the discharge
pipe. Place the pump inside the skimmer or pump
vault being used. Measure the distance between the
center of the outlet pipe and the top of the pump
discharge. Subtract 7" from this number. This is your
'cut-to-fit' reference mark. 1" cut-to-fit reference
marks are molded in both directions on the dis-
charge pipe. Locate the thread size needed for your
pump and count up from there until you find the
correct mark. Cut the discharge pipe and follow the
instructions above to complete installation.
NOTE: If your cut-to-fit reference number is larger than 9 ½", you will need to extend the disharge
pipe. This can easily be done using the supplied 6" discharge extension or standard 2" PVC pipe
and fittings.
4
CUT LINE
1¼"
1½"
GLUE

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Triton tr215cv

Tabla de contenido