Yamaha TSX-140 Manual De Instrucciones página 8

NAMES OF PARTS AND THEIR FUNCTIONS
Rear panel (Connecting antenna)
Notes
• The antenna should be
stretched out.
• If you use an outdoor
antenna instead of the
supplied antenna, reception
will be better.
• If radio reception is poor,
change the height, direction,
or placement of the antenna.
1 FM antenna terminal: Connect the supplied indoor
FM antenna.
2 AM antenna terminal: Connect the supplied AM
loop antenna.
3 GND: Connect the cable core of the Indoor FM
antenna (see below).
4 AUX: Connect an external device. (☞ P. 8)
Connecting an indoor FM antenna to the GND terminal
It is recommended to connect the indoor FM antenna to the GND terminal before connecting to the FM antenna terminal.
1
Remove insulation and twist
the edge of the cord.
Assembling AM loop antenna
4
En
1
2
Fully screw down the GND terminal.
3
Wind the cord around the GND terminal.
Make sure the cord is wound inside of the ring part.
5 USB FOR SYNC.: Connect to PC. (☞ P. 6)
6 15V
: Connect supplied AC adaptor and power
cable.
7 CLOCK: Adjust the clock. (☞ P. 5)
8 ALARM TYPE: Set alarm type of IntelliAlarm
function. (☞ P. 9)
9 Indoor FM antenna (supplied)
Ring
2
3
4
4
Tighten the GND terminal taking care
not to slip the cord off from the
terminal.