Festool MX 1000 E EF Manual De Instrucciones Original página 16

take loads.
Protection against re-starting
Prevents the uncontrolled starting of the de-
vice after current supply cut off. For re-starting,
the device must be fi rst switched off and again
switched on.
6.4 Speed selection switch
(VALID for the type MX 1000/2 E EF)
You can use the speed selection switch [1-9] to
preselect two speed ranges:
1st speed
360 – 630 rpm
The gears can be switched when the machine is
running down, however not under full load.
6.5 ErgoFix interface
Height setting
The working height of the machine can be indi-
vidually adjusted to achieve an upright working
position.
 Push the casing of the ErgoFix adapter [1-7] in
the direction of the machine to move it as far
as it goes [1-7] and hold it tight.
 By pulling on the stirrer rod, you can pull the
ErgoFix adaptor [1-8] out of the machine spin-
dle. In this way, you can adjust fi ve different
working heights. One step is 2 cm. The maxi-
mum adjustment movement is 8 cm.
 Then release the clamping ring of the ErgoFix
adapter [1-7] and check that the adapter [1-8]
is seated securely in the machine spindle.
Quick change function
NOTE
 Ensure that the adapter [1-8] remains clean.
 Do not lubricate the adaptor [1-8].
 Only press the ErgoFix casing [1-7] when the
machine is not in operation.
The ErgoFix interface enables you to easily and
quickly remove the stirrer rod from the machine.
 Push the clamping ring of the ErgoFix adapter
[1-7] in the direction of the machine to move it
as far as it goes and hold it tight.
 By pulling on the stirrer rod, you can pull the
ErgoFix adaptor [1-8] completely out of the
machine spindle.
Changing the stirrer
 Adapter ErgoFix [2-1] after worn-out of stirrer
16
2nd speed
580 – 1010 rpm
rod can be reused.
 Set the wrench [2-2] on the hexagon of the stir-
rer endpiece [2-3] and turn to the left to screw
the stirrer rod out of the ErgoFix adapter [2-1].
6.6 Stirrer
To mix different material mixtures together, use
different Festool stirrers: see the catalogue
PJ Uni
For wall paints,
emulsion paints,
ready-made fi ller,
ready-mix plaster,
varnishes/glazes
RS
For wall paints,
emulsion paints,
pastes, varnishes
casting compounds,
bitumen, sludges
HS2
For tile adhesives,
joint sealant, adhesive
mortar, ready-mix
plaster, screed, fi llers,
levelling compounds
HS3R
For mortar, concrete,
cement and lime
plaster adhesive fi ller,
screed, quartz-fi lled
epoxy resin, thick
bitumen coating
HS3L
For gypsum plaster,
emulsion paints,
varnishes wall paints,
casting compounds
WS
For paints, varnishes,
wall paints, emul-
sion paints, plasters,
glues, tile adhesives