Commissioning; Battery Pack; Capacity Display; Settings - Festool DSC-AGC 18 FH Instrucciones De Uso Originales

English
To put the power tool back into operation, it
must first be switched off and then on again.
Restart protection
The built-in restart protection prevents the
power tool from starting up again automatically
if the power is disconnected during continuous
use. To put the power tool back into operation,
it must first be switched off and then on again.
Overheating protection
In the event of overheating, the safety electron­
ics system switches to cooling mode. The motor
continues to run and the constant speed is de­
activated. Let the machine cool down for ap­
proximately 10–20 seconds before using it
and/or fully loading it again.
6

Commissioning

The dust extraction attachment is preassem­
bled and must not be removed or repositioned.
6.1 Holding the power tool correctly
Hold the power tool with both hands using the
insulated gripping surfaces [1-8]: One hand on
the motor housing behind the switch and the
other on the auxiliary handle [1-3].
6.2 Switch on/off
Switching on [2a]
► Push the on/off switch [1-4] forwards.
Pressing the front part of the switch at the
same time locks the on/off switch.
On/off switch [1-4] is locked and the power tool
is switched on.
Only position the tool on the material once
it has reached operating speed.
Setting the speed
The speed can be adapted in six settings de­
pending on the workpiece requirements.
► Set the speed regulator [1-7] to the re­
quired setting.
Switching off [2b]
► Lift the power tool from the processed ma­
terial.
► Press the rear part of the on/off
switch [1-4].
Lock is released and the power tool is switched
off.
22
WARNING
Risk of injury from kickback, ejected parts
► Before setting down the power tool, wait
until the rotating sanding tool has come to
a complete stop.
► Set the power tool down flat on the dust ex­
traction attachment.
7

Battery pack

► Inserting the battery pack [3a]
► Removing the battery pack [3b]
7.1

Capacity display

The capacity display [1-12] indicates the charge
of the battery pack for approx. 2 seconds after
the button [1-11] is pressed:
Recommendation: Charge the battery pack
*
before any further use.
Further information about the battery pack
and charger can be found in the corre­
sponding operating manual.
8

Settings

WARNING
Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
8.1 Fitting the auxiliary handle [1-3]
Always use the auxiliary handle to ensure
a safe working posture that prevents you
from tiring.
The special "VIBRASTOP" design of the auxiliary
handle helps to reduce vibrations.
► Screw in the auxiliary handle [1-3] on the
side of the thread [1-2] according to the
working method.
70‑100%
40‑70%
15‑40%
< 15%
*