In Case Of Problems - babymoov A014002 Instrucciones De Uso

Problem
• No transmission from the transmitter.
• Transmits without interruption.
• Out-of-range alarm activated without
interruption.
• The out-of-range alarm is activated
sometimes without reason
• The battery low warning is displayed
without interruption.
• The battery life of the receiver is
too short.
• The battery life of the transmitter is
too short.
• A lot of static and interference.
• Too short communication range.
12

IN CASE OF PROBLEMS

Possible cause
• The microphone sensitivity is set too low.
• The batteries have run out or the AC
adapter is not properly connected.
• The microphone sensitivity is set too high.
• The channel or digital code setting is not
the same on the transmitter and
the receiver.
• The batteries of the transmitter have
run out.
• The distance between the transmitter
and the receiver is greater than the
operating range.
• Interferences with other appliances
operating on the same channel.
• The batteries have run out.
• No battery inside the receiver.
• The battery is damaged.
• The night light is on permanently.
• The vibration alarm is on.
• The transmitter is located close to other
electrical apparatus.
• A large number of steel structures
between the transmitter and the receiver.
• Transmitter batterie has run down.
BABY MONITOR EXPERT CARE • Instruction Manual
Solution
• Increase the microphone sensitivity using
the button 2.
• Charge up the battery of the receiver /
install new batteries in the transmitter or
check the connection.
• Decrease the microphone sensitivity using
the button 2.
• Set the same channel and same digital
code on the transmitter and the receiver.
• Install new batteries or use
the AC adapter.
• Bring the transmitter and the receiver
closer to each other.
• Change to another channel.
• Recharge the battery of the receiver using
the charger base / Replace the batteries
of the transmitter or use the AC adapter
for the transmitter.
• Replace the battery in the battery
compartment.
• Contact the customer service.
• Turn off the night light or set to
VOX function.
• Turn off the vibration alarm.
• Remove the electrical appliances or move
the transmitter away from the source of
interference or change the channel.
• Reposition the transmitter and
the receiver.
• Replace the batteries or use
the AC adapter.