Chicco Oasys 23 EVO Instrucciones De Uso página 32

3. R elease the lever checking that it has clicked
into the desired position.
Adjusting the width of the back rest
The width of the backrest can be adjusted to
adapt the child car seat to suit the physique
of the child.
Use the backrest width regulator wheel (K) lo-
cated above the headrest, to adjust the width:
1. R otating it counter clockwise will increase
the width of the backrest (Diag. 19) while
rotating it clockwise will decrease the width
(Diag. 20).
Adjusting the inclination of the child car
seat backrest/seat
It is possible to recline the child car seat by us-
ing the reclining adjuster button (H).
The child car seat backrest/seat can be re-
clined to 4 different positions to allow the
child to travel in absolute comfort.
To recline the backrest simply grasp hold of
the front section of the seat (Diag. 21) and pull
it towards you.
Simply press the reclining adjuster button (H)
pushing the seat backwards towards the vehicle
seat backrest to return it to a vertical position.
WARNING! never recline the child car seat
when in use. Before adjusting the backrest,
remove the child from the child car seat.
After reclining or straightening the Oasys child
car seat, always check that the car 3-point safe-
ty belt is sufficiently taut and a maximum of 2
cm above the shoulder of the child (Diag. 16).
Always perform the above operations when
the vehicle is at a standstill.
Removable backrest/seat covers
The child car seat fabric cover is completely
removable and washable. It is attached to
the structure using velcro straps and elastics
(Diag. 22)
Straighten the backrest (C) upright and widen
the side flaps (N).
Backrest
Start from the lower section of the side flaps,
separate the fabric lining from the Velcro fas-
teners (diag. 23) and lift it off.
Now separate the central section of the back-
rest working from the bottom upwards, re-
moving the entire cover, including the head-
rest section, undoing any elastic fasteners
found behind the backrest. (Diag. 24).
Seat
1. O pen the velcro fastener on the back of the
seat (Diag. 25).
2. P ull the fabric cover so the elastic is taut,
then remove it from the lap belt loop (F) on
both sides (Diag. 26)
3. G rasping both elastics, remove this section
of the fabric cover from the lap belt loops (F)
on both sides (Diag. 27).
4. T he central protection is fastened to the
backrest by two toothed fixtures, pull the
central protection upwards, releasing the
toothed fixtures from their seats (Diag. 28).
5. P ull the cover up over the armrests and remove.
6. N ow finish the removal process by pulling
the triangular plastic reinforcement, fitted
around the reclining adjuster button (H),
upwards (Diag. 29 A and 29 B).
To replace the cover on the frame:
Straighten the backrest upright and widen the
side flaps.
Seat
Start by covering the seat, repeating opera-
tions 6 to 1 in the reverse order, paying par-
ticular attention that the cover fits over all
parts of the frame perfectly, especially around
the two lap belt guides (F) threading the elas-
tics under each of them.
Backrest
Start from the headrest making sure you insert
the elastic and the section of the fabric in the
rear cover. Now fit the cover on, following the in-
structions for operations 1 and 2 in reverse order.
Cleaning and maintenance of the seat
covers
32