Graco MY RIDE 65 Manual Del Propietário página 50

VEHICLE SEAT BELTS
1. Install child restraint and tighten vehicle seat belt.
2. Hold seat belts together at latch plate (fig. a)
then unbuckle.
3. Slide locking clip on seat belts appoximately
1 inch (2.5 cm) away from latch plate.
4. Re-buckle seat belt.
5. Test installation to see if child restraint is secure.
If not secure, additional belt tightening may be
required:
• Unbuckle vehicle seat belt.
• Hold belts together and remove
locking clip.
• Shorten length of lap belt portion
slightly by pulling belt through latch
plate
• Re-attach locking clip.
• Buckle vehicle seat belt.
(continued)
Press child restraint further down into
vehicle seat cushion to help buckle
vehicle seat belt.
Test installation to see if child restraint is
secure. If not secure, repeat above step
until secure.
fig. a
50
within 1"
(2.5 cm)