Tabla de contenido
Publicidad
EN
GENERAL INSTALLATION CONDITIONS
• Before handling or connecting the equipment, please read this manual.
• Do not obstruct the equipment's ventilation system.
• Please allow air circulation around the equipment.
• Do not place the equipment near sources of heat or in excessively
moisture conditions.
• Do not place the equipment where it may be affected by strong
vibrations or knocks.
HOW TO USE THE EQUIPMENT SAFELY
• If any liquid or object falls inside the equipment, please contact a
specialized technician.
• Do not connect the equipment until all the other connections have been
made.
INSTRUCTIONS FOR THE OPTICAL CONNECTION
• For the optical connection, a single mode fibre cable is used with an SC/
APC-type connector.
• Remove the protective cover from the optical connector on the front
panel of the device, and the cap on the connector of the single fibre
cable.
• Connect the cable to the device, carefully slotting the guides together for
both connectors, pushing the connector all the way in.
PRECAUTIONARY MEASURES WITH THE CONNECTION POINT
• Take special care to avoid damaging the unprotected ends of the
connectors, as small scratches, impurities and/or particles of dirt, oil,
grease, sweat etc. may significantly affect the quality of the signal.
• To clean the ends of the connectors, gently rub with a lint-free lens
cleaning cloth, dampened using additive-free isopropyl alcohol. Make
sure the alcohol evaporates fully before connecting.
• Keep the connector covers and cable caps in a safe place in case they
are needed in the future.
• Always fit the covers on the connectors of devices that are not
connected to cables to prevent the laser beam from damaging the eyes.
5
Publicidad
Tabla de contenido
