Cleaning And Maintenance - Ironside 200367 Manual Del Usuario

not leave the heater for a considerable amount of time when in use. Pull the plug
straight out, never remove the plug by pulling on the cord.
Use the appliance in places with good air ventilation, do not position it near a
wall or corner.
When the appliance is in use, keep it far from combustible, explosive articles
or explosive, corrosive gas. Keep the heater far from curtain or places where the
air inlet can easily be blocked.
It is recommended that a separate circuit serving only this appliance be
provided. Keep the power cord far enough from the hot air outlet.
Do not use this heater with a programmer, timer or any other device that
switches the heater on automatically.
The power coupler is waterproof when not in use. In order to prevent possible
electric shock or leakage current, never use the appliance with wet hand or
operate the appliance when there is water on the power cord.
If the supply cord is damaged, it must be replaced by the manufacturer or
service agent or a similarly qualified person in order to avoid a hazard.
In case the motor does not turn after switching on of the power switch, stop
using the appliance and let it repaired by an approved electro technician before
you use it again.
Do not throw the appliance in dustbin with wheels. Do not dispose of electrical
appliances as unsorted municipal waste, use separate collection facilities. Contact
you local government for information regarding the collection systems available. If
electrical appliances are disposed of in landfills or dumps, hazardous substances
can leak into the groundwater and get into the food chain, damaging your health
and well-being. When replacing old appliances with new ones, the retailer is
legally obligated to take back your old appliance for disposals at least free of
charge.

5. Cleaning and maintenance

Before cleaning the appliance, disconnect it from the socket and let it cool
down.
The enclosure is easily to get dirty, wipe it often with soft sponge. For very
dirty parts, wipe with a sponge dipped in < 50
the heater enclosure with clean cloth. Be careful not to let the water enter the
appliance inner.
Do not splash water onto the heater. Never use solvent like gasoline, isoamyl
acetate, toluene etc to clean the heater, in order to protect the enclosure.
Clean the coupler, dry and pack it in a plastic bag.
When you store the heater, let it cool down first, keep it dry. Then cover it with
a plastic bag, put in the packing box and store it in a dry, ventilated place.
water and mild detergent, then dry