Operating Elements; Data Input; Body Analysis - Soehnle Shape Sense Profi 100 Instrucciones De Manejo

A. Operating elements
EN
1. Minus ( )
2. Confirm ( )
3. Plus ( )
B. Preparation
1. Insert batteries.
Note:
Place the body analysis scale immediately on
a solid and even surface (as long as „0,0" is
still displayed) and wait until the scale turns
off automatically.
Only then begin with data input. Note, it
might occur that the initial scale weight is
being added erroneously to the personal
weight process.
The same may happen during regular operati-
on, if scale is held in the hand prior to the
weight process.
2. Place scale level on a solid and even surface
(not carpet). This applies for all measure-
ments.
3. Cleaning and care: use only a lightly damp
cloth for cleaning. Do not use solvents or
abrasives. Never submerge scale in water.
4. A country-specific option, to switch from kg/
cm to lb/in or st/in, is available on the back of
the scale by pushing button.
Attention! Slipping hazard
in case of wet surface.
C. Data input
1. Push button.
2. Use / buttons to select memory slot. Use
to confirm. Þ P
3. Then use /
confirm. Þ H
4. Enter the age and confirm.
Þ A
5. Select gender and confirm (Press
3 sec.). Þ S
4
buttons enter body height and
button
6. Place the body analysis scale immediately on
the floor, wait until screen displays „0,0" and
then step on the scale with bare feet.
The initial measurement is indispensable and
serves to store data for later automatic recog-
nition. If user does not step on the scale, data
cannot be saved and must be entered again.
The first body analysis is performed after a
person steps on the scale.
This scale is equipped with a timeout mode.
It will automatically switch off after approx.
40 seconds, if no buttons are pressed.
Data must be entered again after battery
change.
D. Body analysis
Place scale on solid and even surface. Wait
until scale switches off automatically.
1. Step barefoot onto scale. Stand still.
2. Determined body weight is displayed.
The automatic user recognition follows.
3. If the determined values cannot be clearly
allocated to one user, the possible memory
slots will be displayed.
If the determined weight can be allocated to
more than 2 users, other possible memory
slots will be displayed after 3 seconds.
Use the / keys ( = left,
firm the memory slot displayed there.
The scale measures body values (body fat,
body water) and BMI (Body Mass Index).
The 9-segment status bar shows the respecti-
ve deviation from the normal value (see over-
leaf).
The scale turns off auto matically.
Note: If needed, the user can step off the
scale as soon as the first value appears on the
display.
Classification of body weight according to BMI
(Source: World Health Organisation, 2016)
BMI (kg/m²) classification
< 18.5 Underweight
18.5 - 24.9 Normal weight
25.0 - 29.9 Pre-Obesity
30.0 - 34.9 Obesity level I
35.0 - 39.9 Obesity level II
> 40.0 Obesity level III
= right) to con-