After The Bath; Cleaning, Care And Disinfection; Cleaning And Care - Rotho BABY SPA WHIRLPOOL Instrucciones De Uso

2.8 After the Bath

• After the bath, switch o the air massage buttons
The whirlpool will then switch o automatically after 60 seconds (status display
• Note: An integrated running time limit switches the whirlpool o automatically after 20 minutes.
Press any function button for immediate reactivation of the whirlpool.
• Empty the bath using the supplied draining tube. After that, clean the tub (see 2.9.1).
• Fully charge your Baby Spa Whirlpool after the bath. (see 2.4.2).
• Please complete the disinfection procedure after every second bath (see 2.9.2)

2.9 Cleaning, Care and Disinfection

2.9.1 Cleaning and care

• Please disconnect the mains plug from the power supply before performing any cleaning
and care of the tub.
• Use a sponge or soft cloth. Clean the tub with tepid water and a cleaning agent with neutral pH.
• Use the supplied draining tube to empty the tub.
• Do not use solvents or caustic and abrasive cleaning agents to prevent damage to the surface
of the tub and the jets.
• Next, connect the power pack, fill the tub with little water and rinse it. Drain the water and
operate both air massage buttons for a few minutes to dry the tub – done! (see 2.7.2)
• If in case of very hard water the whirlpool gets clogged with scale, fill the tub up to the "MAX" mark,
add the prescribed dose of a commercially available descaling agent and start the disinfecting
program (see 2.10.2). Next, empty the tub and clean it in the normal manner.
18
and the colour selector button
goes o ).