Cutting Depth Adjustment; Setting For Bevel Cuts; Plunge Cuts - Mafell KSS 80 Ec / 370 Manual De Instrucciones

As this is a switch without locking device, the
machine will only run for as long as this gearshift
lever is pressed.
The built-in electronic system provides for jerk-free
acceleration when the machine is switched on and
under load readjusts the speed to the fixed setting.
In addition, this electronic system adjusts the motor
down in case of overload, i.e. the saw blade will stop.
Switch the machine off then. Then switch the
machine on again and continue sawing at a reduced
feed speed.
The setting wheel 20 (Fig. 2) can be used to adjust
the tool speed in a continuously variable manner
between 2250 and 4400 rpm.
Level
1
2
3
4
5
6
Material groups
- Hardwood, softwood, plywood
Level: 4 - 6
-
- Coated panel materials
Level: 4 - 6
-
- Soft fibre
Level: 6
-

Switching off: To switch off, release the
gearshift lever 8. The built-in automatic brake
limits the saw blade slowing time to approx. 5 s.
The switch-on lock automatically takes effect
again and secures the portable circular saw
against accidental switch-on.

5.3 Cutting depth adjustment

The cutting depth is continuously variable between 0
and 82 mm.
Speed rpm
2250
2680
3110
3540
3970
4400
Proceed as follows:

Press the push-button 11 (Fig. 1) and adjust the
cutting depth with the plunge lever 6.

The cutting depth can be read off scale 13 on
the cover. The surface of plunge lever 6 with the
red background serves as indicator.
Always set the cutting depth
approx. 2 to 5 mm (1/16 to 3/16 in.)
larger than the material thickness
to be cut.

5.4 Setting for bevel cuts

For bevel cuts, the saw unit can be set to any angle
between 0 °and 60°.

In order to incline it, bring the machine into
home position and support it such that it is
possible to tilt the saw unit.

Unfasten the wing nut 10 (Fig. 2)

Adjust the angle according to the scale on the
segment for tilting.

Afterwards, tighten the wing bolt 10.

5.5 Plunge cuts

Danger
Risk of backlash during plunge
cuts! Prior to plunging, place the
machine with the rear edge of its
base plate against a limit stop
fastened on the workpiece. Keep a
firm hold on the machine handle
during plunging and push the saw
lightly forward!

Press the push-button 11 (Fig. 1) and put the
machine in the topmost position with plunge
lever 6.

Completely open the retractable saw guard with
the pre-feed lever 1 (Fig. 2), so that the machine
can be placed onto the workpiece to be
processed. The saw blade is now freely
suspended above the material and can be
aligned with the marking.

Switch on the machine and press the plunge
lever 6 (Fig. 1) downwards. This causes the saw
blade to plunge vertically into the workpiece.
The plunging depth can be read from scale 13.
-22-