Mafell ERIKA 60 E Manual De Instrucciones página 30

Defect
Chip outlet blocked
Height adjustment stiff
Cause
Operation without extraction
Extraction too weak
Wood particles in the chip ejector
Threaded spindle, drive segment,
and guide rod dirty
-30-
Elimination
Remove chips while the machine is
switched off (see Fig. 8 - page 3).
The protective sliding cover 52
must be opened. To do so, detach
screw 51 with the Allen key 22. Pull
the locking recess 50 on the saw
guard downwards and pull the
protective sliding cover forward.
The chips in the chip duct can now
be easily removed downwards.
Afterwards close and engage the
protective sliding cover again.
Caution! Retighten screw 51.
Use an extraction unit, which
guarantees an air speed of at least
20 m/s (65.6 ft/sec.) at the
extraction connection piece
Remove chips with the machine
switched off (see Fig. 8 - page 3).
The protective sliding cover 52
must be opened. To do so, detach
screw 51 with the Allen key 22. Pull
the locking recess 50 on the saw
guard downwards and pull the
protective sliding cover forward.
The chips in the chip duct can now
be easily removed downwards.
Afterwards close and engage the
protective sliding cover again.
Caution! Retighten screw 51.
Clean components and grease or
lubricate