Mortising Chains; Storage; Troubleshooting; Optional Accessories - Mafell LS 103 Ec Manual De Instrucciones

authorised MAFELL customer service shop for
inspection.
Only use our special grease, order No. 049040 (1 kg
tin) for all greasing points.

6.1 Mortising chains

The mortising chain used on the machine should be
cleaned and lubricated in a low viscosity oil bath after
two hours of operation. To do so, dismantle the
mortising chain (see chapter 4.3).
7

Troubleshooting

Some of the most frequent defects and their causes are listed in the following chart. In case of other defects,
contact your dealer or the MAFELL customer service.
Defect
Machine cannot be switched on
Chip ejection blocked
8

Optional accessories

- Guide support stand FG 150
- Slot mortising device SG 230
- Slot mortising device SG 400
- Slot mortising device SG 500
- Clamping device (for SG 400)
9

Exploded drawing and spare parts list

The corresponding information in respect of spare parts can be found on our homepage: www.mafell.com
Notes for after-sales service:
If a LS 103 Ec (with Cuprex motor) is to be mounted on an existing slot mortising device SG 400 or SG 500 at
the customer's (up to year of manufacture 2006), the pinion cpl. (pos. 2), item No 200842 on the slot mortising
device must be replaced by pinion cpl. 204740.
The handle on the pinion cpl. 204740 can be detached by means of the Allen key SW 4 which is included as
accessory with the LS 103 Ec and used to attach the LS 103 Ec on the SG 400 / SG 500.
Danger
Determining the causes for existing defects and eliminating these always
requires increased attention and caution. Pull the mains plug beforehand!
Cause
No mains voltage
Carbon brushes worn
Wood is too damp
-19-
Replace the blunt mortising chains or have them
reground at a MAFELL customer service station or by
a suitable sharpening service.

6.2 Storage

If the machine is not used for a longer period of time,
it has to be carefully cleaned. Spray bright metal parts
with a rust inhibitor.
Elimination
Check power supply
Take the machine to a MAFELL
customer service shop
Order No. 200980
Order No. 200990
Order No. 201000
Order No. 201005
Order No. 039602