Correct Use - IKA MS 3 control Instrucciones De Manejo

• Firmly secure the accessories and vessels in place, otherwise shaking vessels
could be damaged or projected out.
• Check the appliance and accessories beforehand for damage each time you
use them. Do not use damaged components.
• Position one single shaking vessel in the centre and several shaking vessels
so that they are evenly spread out.
• Sharp edged vessels cause wear debris on the attachments.
Beware of the risk of
DANGER
- flammable materials
- glass breakage as a result of mechanical shaking
power
• Do not work with biological or microbiological media.
• Only process media that will not react dangerously to the extra energy pro-
duced through processing. This also applies to any extra energy produced
in other ways, e.g. through light irradiation.
Do not operate the appliance in explosive atmo-
DANGER
spheres, with hazardous substances or under
water.
• Safe operation is only guaranteed with the accessories described in the
"Accessories" chapter.
• Always disconnect the plug before fitting accessories.
• The appliance does not start up again automatically following a cut in the
power supply.
• The appliance may heat up when in use.
For protection of the equipment
• The voltage stated on the nameplate must correspond to the mains voltage.
• The device must only be operated with the original plug-in power supply unit.
• Protect the appliance and accessories from bumps and impacts.
• The appliance may only be opened by experts.
6
Unpack
Unpack
- Please unpack the device carefully
- In the case of any damage a fact report must be set immediately (post, rail
or forwarder)
Delivey scope
- Shaker TTS 3 control
- Power supply
- Standard attachment MS 3.1
- Universal attachment MS 3.3
- One-hand insert MS 1.21

Correct use

Use
4 For mixing liquids
- Touch mode for single test tubes
- Continuous mode for single or several vessels
Range of use (indoor use only)
- Laboratories - Schools
- Pharmacies
The protection for the user is not ensured no more, if the equipment with
accessories is operated, which are supplied or are not recommended not by
the manufacturer or if the equipment in not correct use is operated against
the manufacturer default.
- Microtiter attachment MS 3.4
- Test tube insert MS 1.32
- Operating instructions