Care And Cleaning; General Cleaning; Routine Cleaning - Hamilton Beach FlexBrew 49966 Manual De Instrucciones

Care and Cleaning

w WARNING Electrical Shock Hazard.
Do not immerse cord, plug, or coffee maker in any liquid.
w WARNING Burn Hazard.
Failure to allow coffee maker to cool down may cause hot water or
coffee to spray from the piercing nozzle. Use caution when cleaning.
Cut Hazard.
w CAUTION
Removable single-serve pack holder has a sharp needle. Piercing
needle on underside of lid also is sharp. Use caution when handling.

General Cleaning

1. Unplug and allow to cool.
2. Hand wash all removable parts in hot, soapy water. Rinse and
dry or wash in TOP RACK only of dishwasher. DO NOT use the
"SANI" setting when washing in the dishwasher. "SANI" cycle
temperatures could damage your product.
3. Wipe outside of coffee maker with a soft damp cloth.
Clogged Needle
1. Unplug and allow to cool.
2. Remove the gray removable needle
holder in the lid by turning the arrow
from the locked icon ( ) to the unlocked
icon ( ).
3. Bend a small paper clip. Insert the tip of
the paper clip through the hole of the
piercing needle and up into the shaft of
the piercing needle to ensure grounds
have been removed.
4. To replace the gray removable needle
holder, insert the tab between the lock
icon ( ) and unlock icon ( ) and turn to the right to lock.

Routine Cleaning

All coffee makers should be cleaned at least once a month (once a
week for areas with hard water).
To Clean Carafe Side:
1. Plug into outlet.
2. Press the carafe ( ) button.
3. Pour 1 pint (2 cups/473 ml) of plain white vinegar into the carafe
water reservoir. Place carafe underneath to catch the vinegar.
4. Press the BREW NOW I/ button once. After 30 seconds, press
the BREW NOW I/ button again to stop the brewing and allow
the vinegar to clean. After 30 minutes, press BREW NOW I/
button and allow it to finish the brew cycle. When brew cycle is
finished, empty carafe and rinse. Run 2 to 3 cycles of cold tap
water. The carafe side is cleaned and ready to brew coffee.
5. Unplug.
To Clean Single-Serve Side:
1. Plug into outlet.
2. Press the single-serve ( ) button.
3. Pour 1 cup (237 ml) of plain white vinegar into the single-serve
water reservoir. Place a 14-oz. (414-ml) or larger cup or travel
mug underneath to catch the vinegar.
4. Press the BREW NOW I/ button once. After 30 seconds, press
the BREW NOW I/ button again to stop the brewing and allow
the vinegar to clean. After 30 minutes, press BREW NOW I/
button and allow it to finish the brew cycle. When brew cycle is
finished, empty cup and rinse. Run 2 to 3 cycles of cold tap water.
The single-serve side is cleaned and ready to brew coffee.
5. Unplug.
2
9