Iecex Installation Drawing - PR electronics 9203 Serie Manual Del Producto

Ocultar thumbs

Contenido

página de 45

/ 45
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

LERBAKKEN 10, 8410 RØNDE DENMARK

For safe installation of 9203 the following must be observed. The module shall only be installed by

qualified personnel who are familiar with the national and international laws, directives and

standards that apply to this area.

Year of manufacture can be taken from the first two digits in the serial number.

For Installation in Zone 2 / Division 2 the following must be observed.

The 4501 programming module is to be used solely with PRelectronics modules. It is important

that the module is undamaged and has not been altered or modified in any way. Only 4501

modules free of dust and moisture shall be installed.

IECEx Certificate:

Marking 9203Bxxx

Marking 9203Axxx

Standards

Type

Installation

9203

Non Ex / Zone 2

Ex-Barrier / Zone 2

Installation notes.

Install in pollution degree 2, overvoltage category II as defined in IEC60664-1

Do not separate connectors when energized and an explosive gas mixture is present.

Do not mount or remove modules from the Power Rail when an explosive gas mixture is present.

Disconnect power before servicing.

The wiring of unused terminals is not allowed.

In type of protection [Ex ia Da] the parameters for intrinsic safety for gas group IIB are applicable.

For installation in Zone 2, the module shall be installed in an enclosure in type of protection Ex n

or Ex e, providing a degree of protection of at least IP54. Cable entry devices and blanking

elements shall fulfill the same requirements.

For installation on Power Rail in Zone 2, only Power Rail type 9400 supplied by Power Control Unit

type 9410 (IECEx Certificate of Conformity IECEx KEM 08.0025X ) is allowed.

Revision date:

2015-01-22