Cleaning And Maintenance; Safety Information - Caso MG25 Manual Del Usuario


Select the quantity/weight you require by pressing the Weight button until the
weight will be displayed (100g-1.800g).

After setting the defrost time, press the button Start/Quickstart, to start
automatic defrosting.
► Stop the oven occasionally to remove the unthawed frozen food or to separate it. If the
frozen food has not been defrosted at the end of the estimated defrosting time, proceed
as follows:
► Programme the oven in 100g increments, until the frozen food is completely defrosted.
► When using plastic containers out of the deep-freeze, the defrosting process should only
last long enough to be able to remove the frozen food out of the container, after which it
can be placed into a microwave-resistant container.

15 Cleaning and Maintenance

This chapter provides you with important notices with regard to cleaning and maintaining the
device. Please observe the notices to prevent damages due to cleaning the device
incorrectly and to ensure trouble-free operation.

15.1 Safety information

Attention
Please observe the following safety notices, before you commence with cleaning the device:
► The device must be cleaned regularly and any food residues must be removed.
Insufficient cleanliness of the device can lead to the destruction of the surface, which for
its part can have a negative impact upon the service life of the device and can lead to a
dangerous condition of the device as well as fungal and bacterial contamination.
► Switch the oven off prior to cleaning it and unplug the plug from the wall power outlet.
► The cooking chamber is hot after it is used. There is a danger of burns! Wait until the
device has cooled down.
► Clean the cooking chamber after use as soon as it has cooled down. Extended waiting
unnecessarily complicates cleaning and can make it impossible in extreme cases.
Excessive accumulations of dirt can even damage the device under certain
circumstances.
► If dampness penetrates into the device, this can damage the electronic components.
Please ensure that no liquid can enter the interior of the device through the ventilation
slots.
► Do not use any aggressive or abrasive cleaning agents or solvents.
► Do not scrape off stubborn dirt with hard items.
Setting the quantity / weight
Starting automatic defrost
Please note
66