Cleaning; Troubleshooting; Safety Notices; Fault Indications - CASO DESIGN Touch 2000 Manual Del Usuario

Attention
► Do not use any aggressive or abrasive cleaning agents or solvents.
► Do not scrape off stubborn dirt with hard items.

16.2 Cleaning


Ceramic hob, Housing and Operating Panel
 Clean the hob, the housing of the device and the operating panel with a soft, slightly
damp cloth.
Attention
► In order not to damage the plastic components, do not use any solvent-based cleaning
detergents such as, for example, petrol.

17 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:

17.1 Safety notices

Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.

17.2 Fault indications

In the event of a fault, an error code will appear in the display; it describes the cause of the
fault.
Display Description
E0 No pot detected. Place a pot suitable for induction on the device.
E01, Overheating protection or short circuit. Unplug the device and let it cool down.
E02
E03
Over- or under-voltage. Contact the customer service.
Please note
► If error messages continue to be displayed after an extended waiting period or after
restarting the appliance, then it must be sent to Customer Service to be examined.
46