Control Panel; Operation - CASO DESIGN IceMaster Comfort 3305 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 68

15.1 Control panel

ADD WATER = Add water into water tank
ICE FULL = control lamp (ice basket is full)
ICE= flashes, when device is on, lights when device is working
ON/OFF = on/off button

15.2 Operation

► Please wait min 24 hours before you switch on the ice maker. You will find that the
cooling agent settles out in this time.
► Do not fill in hot water.
► After moving of device wait at least 30 minutes before inserting the mains plug.
 Open the cover of the ice maker and remove the ice basket.
 Check that silicon plug is correctly placed in water outlet.
 Fill water into the water reservoir and observe the min and max marking. Replace the
ice basket. Close the lid of the device.
 Press the "on/off" button to begin the ice making cycle.
 Depending on water and room temperature, the ice making cycle lasts approx. 7 to 15
minutes.
 If water pump can't inject water, the ice maker will stop automatically and signal tone
sounds. The "Add Water" indicator will be on. Press the "on/off" button and fill in water.
 The ice maker stops working when the ice basket is full. In this case the "ICE FULL"
indicator will light up.
 Drain all the water, if unit isn't used. Always store the unit without water in the water
reservoir.
Attention
► Change water in the water reservoir every 24 hours to avoid pathogenic organisms.
Please note
33

Publicidad

Tabla de contenido
loading

Tabla de contenido