Major Components - Out Back Power FLEXpower ONE FP1-1 Manual De Instalación

MATE3 Programming
IMPORTANT:
Programming should be done by a qualified installer who is trained on programming inverter power systems. Failure to program accurate parameters for the
system could potentially cause equipment damage. Damage caused by inaccurate programming is not covered by the limited warranty for the system.
900-0132-01-00 Rev A.vsd\Page-1\2013-01-17
©2012 OutBack Power Technologies. All Rights Reserved.
Components
FLEXnet DC HUB Communication Manager
Battery Monitor (HUB4 or HUB10)
FW250-AC-120V-NA
Surge Protector
(Inside)
System Display and Controller
(MATE3)
Battery Status LEDs
Inverter Status LEDs
MAIN----------------
AC
MATE RTS
IN
SUM STATUS
MATE MATE RTS RTS
Charge Controller
(FLEXmax 80)
Inverter/
Charger
In 23.2 V
Out 27.6 V
0.000 kW
AUX: OFF
FW250-DC-125
(175 or 250)
LED Indicators on the Inverter
Battery Status LED Indicators
Color 12 V Inverter 24 V Inverter 48 V Inverter
Green 12.5 Vdc or higher 25.0 Vdc or higher 50.0 Vdc or higher
Yellow 11.5 to 12.4 Vdc 23.0 to 24.8 Vdc 46.0 to 49.6 Vdc
Red 11.4 Vdc or lower 22.8 Vdc or lower 45.6 Vdc or lower
Inverter Status LED Indicators
Green Inverter on (solid) or standing by (flash)
Yellow AC source in use (solid) or standing by (flash)
Red Inverter error or warning (see manual)

Major Components

FLEXpower System Products
Inverter/Charger
AC Conduit Box
DC Conduit Box
System Display and
Controller
3:02:14P
INV
SETUP ADV
Charge Controller
Communications
Manager
Remote Temp Sensor
FLEXnet DC Monitor
Surge Protector
Customer-Supplied Components
AC Source
Main Electrical Panel
(or overcurrent device for AC source)
Electrical Distribution Subpanel
0.0 A
0.0 A
0.0 kWH (Load Panel)
Sleeping
Battery Bank
Photovoltaic (PV) Array
(with PV Combiner Box [PV8 or PV12])
FNDC LED Indicators
Color Battery State-of-Charge
Green > 90% (blinks if charge parameters are met)
≥ 80%
Yellow
≥ 70%
Yellow
≥ 60%
Yellow
Surge Protector LEDs
≥ 60% off, < 60% solid, < 50% blinks
Red
Active Error Phase
Contact Technical Support:
Yellow Red DC
Telephone: +1.360.618.4363
Yellow Red AC IN
Email: Support@outbackpower.com
Yellow Red AC OUT
Website: www.outbackpower.com
IMPORTANT:
Not intended for use with
life support equipment.
FX Series
VFX Series
GTFX Series
GVFX Series
GFX Series
FW250-AC-120V-NA
FW250-DC-125
FW250-DC-175
FW250-DC-250
MATE2
MATE3
FLEXmax 60
FLEXmax 80
HUB4
HUB10
RTS
FNDC
FW-SP-ACA
Utility Grid, or
AC Generator