EHEIM classicLED daylight Manual De Instrucciones página 12

English
4. Commissioning
Fitting the LED holder
1. Lay the mains cable c along under the LED light a (⌦A).
2. Push the LED holder b approx. 2 – 3 cm over the LED light edge.
3. Turn the LED holder by 90° in a clockwise direction (⌦B).
4. Press the LED holder downwards until the LED light engages (⌦C).
5. Adapt the length of the LED light to your cover frame by moving the LED holder accordingly (⌦D).
6. Fasten the cable in the LED holder with the snap fittings (⌦E).
7. Set the LED light in the cover frame d. Ensure that the LED light is firmly seated (⌦F).
8. Feed the cable into the cover frame and through the rear opening to the outside.
‧ For maintenance work, the LED light can be pushed into the cover frame (⌦F).
‧ The LED light can be directly placed on an open aquarium with the holder.
5. Operation
Switching the LED on/off
DANGER! Electrocution due to penetrating water!
The LED light is only protected against penetrating water if immersed temporarily.
▶ The distance from the underside of the light to the highest water mark must be a minimum of 15 mm (⌦G).
The power supply unit is not protected against penetrating water!
▶ Never mount the power supply unit on or in the cover frame.
1. Connect the plug f of the LED light to the socket of the power supply unit e (⌦H).
2. Tighten the plug with the union nut (⌦I).
3. Insert the mains plug in the mains socket.
Optional accessories (not included in the scope of delivery)
Adapter set T5/T8
(EHEIM item no.: 4200130)
With the T5/T8 adapter, you can replace traditional fluorescent bulbs with the EHEIM classicLED.
The T5/T8 adapter set is available as an original EHEIM accessory.
The set includes:
‧ 2 × T5 adapter j (⌦L)
‧ 2 × T8 adapter j (⌦L)
‧ 2 x clamping ring i (⌦L)
‧ 2 x holder for mounting the LED light underneath the sockets h (⌦J)
‧ 2 x holder for mounting the LED light laterally next to the sockets g (⌦J)
DANGER! Electrocution!
▶ Before all assembly work, remove the mains plug of the lighting unit and or cover.
▶ Keep the lighting unit or cover disconnected from the mains!
▶ Secure the mains plug of the lighting unit or cover against any unintentional connection to the socket.
With the holder for mounting underneath the sockets, the minimum distance of 15 mm from the underside of the
LED light to the water surface may not be able to be adhered to, depending on the aquarium. If this is the case,
use the holder for lateral mounting g (⌦J).
1. Push the correct holder until it locks onto the LED light (⌦K).
2. Push the clamping ring i and the T5 or T8 adapter j together until they lock onto the holder bracket (⌦L).
3. Loosen the end cap k and remove the fluorescent bulb.
4. Insert the LED light with the T5/T8 adapter into the lamp socket l via the end cap (⌦M).
5. Screw down the end cap (⌦N).
12