Sears Kenmore Elite ULTRA WASH 665.1392 Serie Manual De Uso página 18

_,_,,_ _,y_ _j_,y_C_ __I_S_y_'_O _+
Delay Hours (on some models)
Use this option to run your dishwasher during off-peak hours. Local utility providers recommend using energy during off-peak
hours when possible.
To delay the start
1. Select a wash cycle and options.
2. Press the delay button to choose the number of hours to be delayed.
3. Press START/RESUME.
NOTE- Anytime the door is opened (such as, to add a dish), the START/RESUME button must be pressed again, to resume the
delay countdown.
Control Lock Option
Use the Control Lock option to avoid unintended use of the dishwasher between cycles. When LOCI< ON is lit, all buttons are
disabled. The dishwasher door can still be opened/closed while the controls are locked.
To turn on the Lock
Press and hold CONTROL LOCI< for 3 seconds. LOCI< ON will light up. If you press any pad while your dishwasher is locked,
the light flashes 3 times and an audible tone will sound.
NOTE: The dishwasher cannot run if the control is locked.
To turn off the Lock
Press and hold CONTROL LOCI< for 3 seconds. The light turns off.
Indicators and Countdown Bar (on some models)
The indicators will inform you if you are able to add a dish to the cycle
after it started. It will also inform you if the dishwasher is washing, rinsing,
drying, complete, and/or sanitized. They will show whether the control is
locked and/or the delay option is selected. A series of bars will count clown
the duration of the cycle remaining from left to right. Each bar equals
approximately 24 minutes of cycle length. The bars will also count clown
the delay feature from left to right, and the delay indicator will be
activated.
Selecting Cycles and Options
1. Select the desired cycle. If you want to run the last cycle that was completed, you can simply press START once to show
which options you used, then press START again to start the cycle.
2. Select the desired options. Not all options are available for every cycle. If an invalid option is selected for a given cycle,
the lights will flash.
Turning OFF/ON the Sound
Press and hold HIGH TEMP for 3 seconds to toggle sound ON and OFF. The sound will not deactivate for cycle interrupt or
service required messages. A screen on the Text LCD will confirm when the sound has been turned off or on.
18