Safety Instructions; Installing The Battery - Extel SUNPOWER 30 Instrucciones De Uso

1

SAFETY INSTRUCTIONS

Important!
• Please read the user manual thoroughly before installing or using this product.
• If you install this product for other people, please give the manual or a copy to the end user
Warning:
• The different elements can only be dismantled by an authorised technician. .
Safety instructions:
• To safely use this system, it is essential the fitters, users and technicians follow the safety procedures described
in this manual.
• Specific warnings and caution symbols are indicated on the elements if necessary
Warning:
Follow these instructions:
• The only connections made should be those provided in this manual: making any incorrect connections could be
dangerous and could seriously damage the system.
• In view of the risks that may arise during the installation and usage phases of the product components should be
installed in accordance with the following recommendations: Do not make any modifications of any kind to any
parts of the device unless those modifications are described in this guide. Unauthorised operation will only lead
to operating problems. The manufacturer accepts no liability for damage resulting from products that have been
modified arbitrarily.
2
DESCRIPTION
1 • 30W polycrystalline pre-wired (3m) solar panel, 12V
3 • 3m cable (3 wire)
5• Support of lamp x2*
7 • Battery12V/18Ah
9 • 12V/USB 5V cigarette lighter converter
Warning: Products incompatible with 230V
3
INSTALLATION
a. Installing the battery
- Install the battery inside the control unit and connect it, making sure to match up the +/- poles (fig.3)
- Attach it using the retaining lug supplied (fig.3-2).
Note: The performance of the storage cell charge depends on the temperature of the surrounding environment
where it is installed. Optimum efficiency is obtained in moderate temperatures, whereas it is significantly reduced
at low temperature.
b. Wiring
Note: the panel is pre-wired.
- Cut the cable according to your installation
1: panel connection to the control box
2: switch connection to the control box. The bridge is essential and must not be forgotten.
1GB
(fig. 1)
CFI EXTEL SUNPOWER 30 - 01/2011 - V1
2 • Double On/Off switch*
4 • 12V/5 W LED light x2*
6 • 3m cable (2 wire) x2
8 • Control box
10 • Adapter with cigarette lighter plug x2