Oster GCSTES-100 Manual De Instrucciones página 16

Warning: When filling the water tank, watch for water that can drip onto the floor and
cause you to slip and fall.
Tip: It is not necessary to have a full tank of water for the Steamer to generate steam.
For best results, just make sure the water tank is at least half full.
4. Close the water-fill cover, push the water tank into the steamer body until a 'click'
sound is heard.
Note: If you need to add water while steaming, unplug the steamer, wait until it cools
and follow above steps. If a loud vibrating noise is heard, then the water level is low
and needs to be refilled.
USING YOUR STEAMER VERTICALLY
You can use your Steamer in the vertical position to press with steam hanging garments
and drapes.
Caution: Heated press bar gets hot. Do not touch!
1. Hang your garment to be steamed on a clean, rust-free hanger.
2. Plug unit into a standard electrical outlet.
Warning: Care should be taken to arrange the cord so that it cannot be pulled or
tripped over. Always make sure you can move freely without getting tangled with the
cord.
3. The red ready indicator light turns off and will cycle on and off as the temperature is
maintained.
Caution: Burns could occur from touching hot metal parts, hot water, or steam. Use
care when you turn a steam appliance upside down – there may be hot water in the
reservoir.
4. You are now ready to start steaming!
5. Turn the continuous steam switch on
6. Hold your Steamer by the handle in vertical position with the head pointing toward the
fabric and away from you and your body.
Warning: Steam is hot. Always point steamer exit away from yourself, other persons,
pets, plants and walls. Never steam clothes while they are being worn.
7. With your free hand, pull the fabric tight.
8. Press the shot of steam button to generate bursts of steam.
Caution: do not press the shot of steam button before the ready indicator light turns
off or if the unit is off.
9. Touch the fabric lightly with the heated press bar, moving it in a downward motion,
beginning at the top of the garment and moving downward.
Caution: The heated press bar gets hot, do not touch.
10. Repeat this step until fabric is wrinkle free.
Tip: For more difficult wrinkles, try steaming from the underside of the fabric.
11. When finished, move trigger switch on the back of the steamer to the Off position.
12. Place Steamer on a flat surface and unplug from electrical outlet.
13. Wait until Steamer has cooled and empty water tank.
Note: Always unplug the Steamer when not in use.
English - 5