Leggett & Platt Perfomance Serie Manual Del Propietário página 19

REMOTE CONTROL PROGRAMMING (1 remote control - 1 base)
Program One Remote to Operate One Base - perform the
following numbered procedure.
STEP 1
Unplug the adjustable base electrical power
cord. Wait 30 seconds, then plug the cord back
into the power source.
STEP 2
Locate the control box, attached to the
underside of the base (FIGURE 16). The
control box will be mounted in a housing.
FIGURE 16
CONTROL BOX
STEP 3
On the control box, press the learn button two
times in short succession. A green LED will
illuminate and stay on (FIGURE 16).
STEP 4
On the remote control, simultaneously press
and hold the HEAD UP and FLAT buttons
(FIGURE 17). The green LED on the control
box will shut off.
One remote control is now programmed to
operate one base.
TO RELEASE PAIRING OF REMOTE CONTROL
- PRESS LEARN BUTTON FOUR (4) TIMES
UNTIL GREEN LED LIGHT STAYS ON, THEN
PRESS LEARN BUTTON ONE (1) MORE TIME
TO CONFIRM.
GREEN LED
LEARN
BUTTON
NOTE
HEAD UP
BUTTON
FIGURE 17
Performance Models Signature Owners Manual 99301468-b
FLAT
BUTTON
19