Spray Function - EASYOU SIMPLE MOVE SYIR-I016 Manual De Instrucciones

1. Fill in the water tank of the iron as described above in : Filling the water tank part
2. Place the iron on the charging base and plug in the base with the power cord.
3. The circle on the charging base gives a blue light. This means that the base is plugged.
4. The signal lamp then turns red (Fig A). This means that the iron is plugged and
charging.
5. Once the iron is hot, turn the
6. Steam ironing is possible only when the highest temperatures shown on the
temperature control are selected. Otherwise, water could leak from the soleplate.
7. Wait until the light is off (Fig B). This shows that the selected temperature has been
reached.
8. Set the switch to the steam position :
9. Once ironing is over or during breaks, place the iron on its charging base or place it
vertically.
NB : When your water tank is empty, set the switch to the no steam position :

Spray function :

Spraying steam sends extra water on clothes to eliminate the creases.
1. Turn the temperature control knob on MAX and wait until the light is off. This will
mean that the desired temperature has been reached.
2. Aim the spray toward the garment, then press the spray button to send water on the
garment
Advice : For a maximum quality, do not spray more than three times in a row.
Several pumping actions are necessary to start this function. Keep in mind that an
excessive use of this function will cool the iron.
Jet steam function :
Steam jet sends a powerful gust of steam onto garments to eliminate the creases. This
function is also necessary for thicker textiles such as curtains.
1. Place the temperature control knob on MAX and wait until the light is off. This will
mean that the desired temperature has been reached.
2. Press the jet button to produce a gust of steam which can penetrate the fabric and
smooth the more difficult and stiffest creases.
Auto-clean function :
1. Fill in the water tank and place the temperature control knob on MAX
2. Plug in the apparatus, the lights on the charging base and the iron must be on
button on the desired position.
temperature control
52