Pet Immunity; Receiving Channels With The Pet Immune Function - AVS Electronics One Serie Manual De Instrucciones

Pet Immunity

The pet immunity function is used to identify small animals less than 40 cm tall and features an adhesive filter which
is applied internally.
N.B.: as this function does not allow the Infrared Anti-masking to be used, DIP 7 on bank SW2 must be set
to OFF(except the OnE PA WS)
Applying the filter:
9 mm
18 mm
- Remove the black lens support by forcing the side of the cover as shown in figure 1
- Remove the black lens support by lifting it as shown in figure 2
- Apply the adhesive filter to the black lens support starting from the point shown in figure 3
- Make sure the adhesive filter is applied on the crack of the black lens support as shown in figure 4
- Put the black lens support back in place

Receiving channels with the Pet Immune function

The figure shows the coverage zone where application of the filter allows unprotected low zones to be created.
Sensor
Adhesive filter for Pet Immunity
5 m
P
- 21 -
E
N
G