Wet Vacuum Cleaning; Blowing Function - SPARKY VC 1221 Instrucciones De Uso

and screw the locking cap to close the filter basket. Af-
ter prolonged use the cartridge filter must be cleaned by
tapping and brushing it.
When vacuuming concrete or similar materials generat-
ing fine dust, the cartridge filter must be brushed and
dusted off more often. This is an important prerequisite
for the reliable operation and long life of your vacuum
cleaner. If you notice that the suction force decreases or
in case you ascertain that the cartridge filter is damaged,
you must replace it immediately with a new one.
Dust bag
▪ Slide the dust bag flange over the hose connection
(Fig.10) on the inner side of the tank. Press it until it
snaps firmly into place (Fig.11) taking care not to dam-
age the dust bag.
The use of improper dust bag voids the guarantee.
Check the dust bag (14) regularly and change it when it is
2/3 full. The bag is designed in such way that only air, and
no dust, can pass through the paper. Therefore a used
dust bag may not be reused.
Do not use the dust bag for vacuuming up objects with
sharp edges or wet objects.
▪ Place the upper section on the tank once again and
close the clamps.
▪ Place the large end of the hose on the front air intake
stub on the tank.
▪ Select the desired nozzle (13,15) or tube (11) and con-
nect it to the hose (10).
▪ Make sure that the ON/OFF switch (2) of the appliance
is in "OFF" position „O" before you insert the power
plug into the socket.
▪ Insert the power plug into the socket.
▪ Switch the motor on (ON/OFF switch in position "I").
▪ When you have finished vacuuming, switch the motor
off by putting the ON/OFF switch (2) in „OFF" posi-
tion „O".
▪ Unplug the vacuum cleaner.

WET VACUUM CLEANING

WARNING: Never vacuum up hazardous ma-
terials.
▪ Make sure that the appliance is unplugged.
▪ Check to make sure that the tank (7) is free of dust
and dirt.
▪ The appliance is shipped from the factory with a car-
tridge filter. Remove the cartridge filter (21), which is
not appropriate for wet vacuum cleaning.
▪ Remove the dust bag (14) and the dry filter (22) in case
you have used them prior to wet vacuum cleaning.
▪ Place the foam filter (19) (Fig.12) on the filter basket.
▪ Place the upper section on the tank and close the
clamps.
▪ Place the large end of the hose on the front air intake
stub on the tank.
▪ Select the necessary nozzle (13,15) or tube (11) and
place it on the hose (10).
▪ Make sure that the ON/OFF switch (2) of the appliance
is in "OFF" position "O" before you plug the appliance.
▪ Insert the plug into the socket.
6
EN
▪ Switch the motor on by placing the ON/OFF switch (3)
in position "I".
▪ When you have finished wet vacuuming, switch the
motor off by putting the ON/OFF switch (2) into the
„OFF" position „O".
▪ Unplug the vacuum cleaner.
▪ After use, empty and dry the tank (7).
Tip: If you want to vacuum up a large quantity of liquid
from a sink or a tank, please don't put the entire suc-
tion nozzle in the liquid; rather leave a little space so that
some air can also be drawn in along with the liquid.
The appliance is equipped with a float switch (5) (Fig.13)
that will stop the vacuuming when the tank is full. You will
notice that suction has stopped by the motor now run-
ning faster. At this event, switch the appliance off and
unplug it.
Be aware that the full tank can be very heavy.
After wet vacuuming, switch off the appliance and un-
plug it. Empty the container and clean/dry it inside and
outside prior to storage.
IMPORTANT! After wet vacuuming, please proceed as
described in the section entitled „Dry vacuum cleaning"
before you attempt to dry vacuum again.

BLOWING FUNCTION

Remove the upper hook (23) for winding up the cable.
Insert the larger end of the hose into the orifice in the up-
per rear part of the vacuum cleaner. The hose connector
tooth shall align with the groove in the blow connector.
(Fig.14)
WARNING: Never turn the air flow towards
people, animals or objects as the outcoming air may
be hot.
ACCESSORIES
MODEL
Hose set
2-part plastic tube
Dust bag
Dry filter
Foam filter
Cellulose pleated filter
Floor nozzle
Crevice nozzle
Wheels and castors
Castor pedestals
WARNING: Use only original SPARKY ac-
cessories. The use of non original spare parts or
accessories presents potential danger and voids the
guarantee.
VC 1221
•
•
•
•
•
•
•
•
2 wheels +
2 castors
2
VC 1221