Transport And Storage; Maintenance; Malfunctions; Technical Specifications - Bremshey Sport Sprinter Control Manual Del Usuario

tRANSPORt AND StORAGE

Please follow these instructions when carrying
and moving the equipment, because lifting it
incorrectly may strain your back or risk other
accidents:
Standing in front of the device, tilt the device
slowly towards you, and push from the front
and push along the floor on the wheels at
the front support. We recommend that you
use a protective base when transporting the
equipment.
To prevent the equipment malfunctioning,
store in a dry place with as little temperature
variation as possible and protected from dust.

MAINtENANCE

The equipment requires very little
maintenance. Check, however, from time-to-
time that all screws and nuts are tight.
•
After exercising, clean the equipment with a
soft, damp cloth. Do not use solvents.
•
Never remove the equipment's protective
casing.

MALFUNCtIONS

Despite continuous quality control,
NOtE!
defects and malfunctions caused by individual
components may occur in the equipment. In
most cases it's unnecessary to take the whole
device in for repair, as it's usually sufficient to
replace the defective part. Always give the
model, serial number of your equipment and
in case of malfunctions also conditions of use,
nature of malfunction and any error code.
When you encounter unusual behavior from
the device, contact your local Bremshey Sport
dealer for service.
If you require spare parts, always give the
model, serial number of your equipment and
the spare part number for the part you need.
The spare part list is at the back of this manual.
Use only spare parts mentioned in the spare
part list.
6

tECHNICAL SPECIFICAtIONS

Length ..............................................................108 cm
Width .................................................................. 54 cm
Height ...............................................................110 cm
Weight ................................................................. 45 kg
The Sprinter-control meets the requirements
of the EU's EMC Directives on electromagnetic
compatibility (89/336/EEC). This product
therefore carries the CE label.
The Sprinter-control meets EN precision and
safety standards (EN-957).
Due to our continuous policy of product
development, Bremshey Sport reserves the
right to change specifications without notice.
The instructions must be followed
NOtE!
carefully in the assembly, use and maintenance
of your equipment. The warranty does not
cover damage due to negligence of the
assembly, adjustment and maintenance
instructions described herein. Changes or
modifications not expressly approved by
Bremshey Sport will void the user's authority to
operate the equipment and any warranty!
wE wISH YOU MANY ENJOYABLE tRAININGS!