BH FITNESS Nevada Plus G119X Instrucciones De Montaje página 24

(72) Bolts M-10x15.
(73) Bolts M-10x25.
(74) Bolts M-10x35.
(75) Bolts M-10x50.
(76) Bolts M-10x65.
(77) Bolts M-10x75.
(78) Bolts M-10x95.
(79) Bolts M-10x100.
(80) Bolts M-10x105.
(81) Bolts M-12x75.
(82) Bolts M-12x135.
(83) Flat washers M-5.
(84) Flat washers M-8.
(85) Flat washers M-10.
(86) Washers M-10.
(87) Flat washers M-12.
(88) Flat washers 19x40.
(89) Flat washers 26x40.
(90) Flat washers 13x42.
(91) Self-locking nut M-10.
(92) Self-locking nut M-12.
1.-Place the
horizontal position (lying flat) on a
table or other level surface Fig.4.
2.-Place the bases (5-6) onto the main
body (4), as shown in Fig.5, ensuring
the stickers on the left and right match
up, and tighten the screws (78).
3.-Fit the support leg (3) tightening the
bolts (79) against the rear plate Fig.6.
4.-Put the screws (79) into the screw
holes so that they are in their correct
position, without
Make sure the main structure (2)
remains in a vertical position Fig.6.
5.-Fit the top body (1) Fig.7 onto the
main body (4). Hand tighten the nuts
(91) as shown in Fig.7.
main frame (4)
tightening
FITTING THE BUTTERFLY
ARM SUPPORT.-
6.- Fit the butterfly arm support (8) into
the top support (1), Fig.8. Insert bolt
(82), along with washer (87) and nut
(92), and tighten securely. Fit the nut
cap (57).
FITTING THE ARM LIMIT
PLATE.-
7.-Take the nuts, washers and bolts
off the arm rotation support Fig.8.
Next, fit the plate (29) with the logo
facing outward and refit the bolts,
washers and nut,
Tighten the bolts securely.
FITTING THE TOP FOAM
COVERS.-
8.-Take the foam covers (65) and fit
them onto the two BUTTERFLY bars,
in as shown in Fig.8.
Now take the handle (21), remove the
bolt and the washer Fig.8 and screw it
on to the arms (left and right).
FITTING THE SEAT
STRUCTURE.-
9.-Remove the bolt from the seat
support (79). Position it on one of the
seat height setting holes Fig.9 and
secure
previously.
Fit the seat locking pin (39).
Fig.6.
FITTING THE HANDGRIP
SUPPORT.-
10.- Fit the handgrip support (11) onto
the tube for the seat frame (12), Fig.9.
Next, insert bolt (77), flat washer (85)
and tighten using nut (91).
24
using the bolt removed