How To Use The Demolition Hammer - Metabo HPT H 65SC Manual De Instrucciones

(1) Clean, then smear the tool shank with
grease or machine oil. (Fig. 2)
(2) Rotate the stop lever 180° in a clockwise
direction while pulling it toward you.
Next, insert the tool shank into the
hexagonal hole on the front cover. (Fig.
2)
(3) Clamp the tool by turning the stop lever
by half a turn in the opposite direction.
(Fig. 3)
NOTE:
When removing the tool, follow the above
procedures in reverse.

HOW TO USE THE DEMOLITION HAMMER

1. After placing the tip of the tool on concrete
surface, switch ON.
The switch can be turned ON if the trigger
is pulled and OFF when it is released.
If the lock-on button is pressed while the
trigger for the switch is pulled, even if your
finger is released from the trigger, the
switch remains ON - convenient for
continuous operation.
To turn the switch OFF, pull the trigger
again, and the lock-on button will release.
2. In some cases, it is necessary to thrust the
tip of the bit against the crushing position
forcibly in order to begin the striking
motion.
This is not due to malfunction of the tool. It
means that the safe guard mechanism
against no-load striking is working.
3. By utilizing the empty weight of the machine and by firmly holding the hammer by both
hands, you can effectively control the subsequent recoil motion.
Proceed at a moderate work-rate, the use of too much pushing force will impair efficiency.
NOTE:
Sometimes the tool does not begin the striking motion even when the motor rotates
because the oil has become thick.
If the tool is used at low temperatures or if it is used after being idle for a long time, the
tool should be run for five minutes in order to warm it up.
Tool shank
2
3
Stop Lever
Fig. 2
Stop Lever
Fig. 3
Fig. 4
English
Front Cover
1
9