Fracarro SIG7340 Instrucciones De Uso página 27

IMPORTANT: The CAM menu depends on the specific model acquired. Full interaction with some types of
CAM might not be possible using the TPE (refer to the technical specifications of the CAM manufacturer).
In the "CAM CONTROL" MENU, all the messages from the CAM when it is operating can be displayed; it is also
possible to interact with the CAM using TPE. A message "Not allowed" is displayed in the event that the CAM
does not need the user's intervention. To visualize the CAM MENU use the OSD mode.
COMMON
INTERFACE
O.
5.2.6 COMMON INTERFACE MENU
CAM RESET
CAM CONTROL
CI MENU
CAPMT Update
CAPMT
management
CAPMT resize
NB. Advanced options subjected to changes according to the Firmware version.
Confirm the settings by pressing the
pressing the S key after the modules programmation.
Reset hardware of
the CAM module
CAM status
module verification
Enter the OSD
navigation of the
CAM
Update Over write
Incremental
Sequential
If it is enabled, the CAM is set to only decode
the audio and video of a program; in this
ON OFF
disabled, it decoded everything: audio, video,
key; save the settings by
27
Advanced functions to
modify the management
of the CAM's decryption
case, the number of the decoded
programmes could be higher. If is it is
TTX, subtitles, MHP and etc.