Disposal; Assistance And Warranty - Imetec F4101 Instrucciones De Uso

GB
The steam (ready) LED (5) does
not light up or water leaks from
the boiler cleaning cap (12).
Patches remain wet while ironing.
The iron must not rest in vertical
position.
The product is packaged in recyclable materials. Dispose of it in compliance with the
environmental protection standards.
The product must be disposed of appropriately, in compliance with European
standard 2002/96/EC. The recyclable materials contained in the appliance must be
recovered so as to prevent environmental pollution. For further information, contact
the local disposal body or the appliance dealer.

ASSISTANCE AND WARRANTY

To request repairs or purchase spare parts, please contact IMETEC's authorised customer
service centre on the Toll-Free Number below or via the website. The appliance is covered
by the manufacturer's warranty. For details, read the attached warranty sheet. Failure to
comply with the instructions for use and maintenance provided in this manual will render the
manufacturer's warranty null and void.
»Ä·¹Ê· ÈÅËÆ  Æ
16
The cleaning cap (12) has not
been tightened correctly.
Sometimes patches remain wet after
being steam ironed as the steam
condenses on the ironing board. Pass
the iron a number of times on the wet
patches without dispensing steam. If
the lower part of the ironing board is
wet, dry it with a dry cloth.
The iron has been designed to be
set horizontally.

DISPOSAL

www. imetec.com
¿· ¿»ÃÅÄÊ»
»Â ·Î
Make sure the cleaning cap is tightened
well. Use a coin to tighten the cleaning
cap (12).
Use a mesh ironing board to prevent the
steam from condensing on the ironing
board.
Place the iron on the heat resistant mat.
ÐзÄÅ  ·ÅÂÅ