LD Systems LD STINGER Serie Manual De Usuario página 7

INpuT
1
Both 4-pole Speakon sockets are parallel wired and can be used for both operating modes, Fullrange and
Biamping mode.
If one socket is used as Input, the other socket can be used as Link Output.
For Fullrange mode (operating mode switch
sockets are used. Frequency separation for high and low frequencies will be done by the internal passive
crossover.
For Biamping mode (operating mode switch in
are used for low frequencies (woofer) and pin 2+ and 2- are used for high frequencies (tweeter). Frequency
separation has to be done by an active crossover (LDDS21 or LDDPA260) before amplification (recommended
crossover frequency 1000Hz).
opERaTING ModE SWITcH
2
For Fullrange mode set to FULLRANGE.
For Biamping mode set to BIAMPING.
Back paNEl / controL ELEmEntS:
2
in position FULLRANGE) only pin 1+ and 1- of the SPEAKON
2 position BIAMPING) pin 1+ and 1- of the Speakon sockets
7