Kenmore 106.7639 Manual De Uso página 6

Install Levelers
IMPORTANT: Lay down the refrigerator ONLY to your left-hand
side (as you are looking at the front of the refrigerator), to avoid
damaging the refrigerator.
1. Locate the levelers. They are enclosed in a plastic bag inside
the crisper drawer.
2. Using two or more people, access the bottom of the
refrigerator either by tilting it first to one side and then the
other, OR by laying it down on the floor to your left-hand
side, as shown.
Tilt the refrigerator to the side enough to access the
bottom. Using a ³⁄₈" hex driver, remove the two screws
attaching the wooden runner to the bottom of the
refrigerator. Then install a leveler to the front corner.
Repeat for the opposite side.
NOTE: The refrigerator cabinet should not touch the
floor without a leveler installed.
A
A. Remove runner.
B. Install leveler.
6
B
OR
Using the packaging corner posts (left-hand side, front
and back) as a cushion, lay the refrigerator down on the
floor (to your left-hand side only), as shown in the
following graphic.
NOTE: Using the packaging as a cushion will help avoid
denting or scratching the refrigerator.
Using a ³⁄₈" hex driver, remove the two screws attaching
each wooden runner to the bottom of the refrigerator.
Install a leveler to each of the front corners.
A
C
A. Remove runner.
B. Install leveler.
C. Packaging corner post
Clean Before Using
After you remove all of the package materials, clean the inside
of your refrigerator before using it. See the cleaning instructions
in "Refrigerator Care."
Important information to know about glass shelves
and covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
Tempered glass is designed to shatter into many small,
pebble-size pieces. This is normal. Glass shelves and covers
are heavy. Use both hands when removing them to avoid
dropping.
B